Networking and Bluefin High Density Signal document. The latest version will be available Processing (HDSP) are registered trade marks of Calrec Audio Ltd. Dolby ® E is a registered trade Tel +44 (0)1422 842159 upon request. This publication is for International Fax +44 (0)1422 845244 usage.
Omega COntents Important Information Hydra Audio Networking Health and Safety Hydra Technology Technical Support Typical Hydra Network Example Console Hardware Overview Gigabit Switch System Overview Hydra fixed format Boxes Environmental Considerations Modular Hydra I/O Box Input/Output Port Labelling Fibre Optic Interfaces...
April Calrec customer support engineer before carrying out any form of re- Calrec and variations to the recommended 2006 the vast majority of Calrec PCB and soldering. installation as detailed in Calrec cable assemblies will have been produced documentation.
The maximum potential between the terminals exceeds 60 volts, the blanking plates are fitted to avoid the risk of electric shock. CalreC Putting Sound in the Picture...
Calrec Repairs For technical assistance within the UK If you need to return goods to Calrec, and Ireland, please contact the Customer for whatever reason, please contact the Support Team at :- Company beforehand in order that you...
Page 9
**Wide Area Bulk Cards are used to expand the I/O of the system via a wide area interface such as MADI, or Hydra - Calrec’s sophisticated audio Hydra I/O units can interface up to 96 inputs networking system. HYDRA I/O UNIT and 96 outputs, analogue or digital.
Non-operating: 0% to 90% non suitable fixings during transit to prevent condensing. movement, and possible damage. Calrec Audio Ltd is not liable for any damages to Altitude the touch screen, the touch screen arm,...
& suffixes are not applied. connections are stored with the snap-shot memories. Note that I/O marked in this way cannot be connected in pairs to stereo paths from the control surface. CalreC Putting Sound in the Picture...
The system can be pre-set with up to adjustable globally from +24 to +36 dB in five external sync sources, plus internal, 2 dB steps such that if the 1st source fails, it will automatically switch to the 2nd, and so on. 12 Omega with Bluefin...
There is also no space to fit either a surround spill or joystick panel, though surround images can still be adjusted in other ways. 1 Omega with Bluefin...
40 Fader Frame 50.8 1290 33.3 15.5 56 Fader Frame 70.7 1796 33.3 15.5 The end profile is the same for all three frame sizes. The floor stand shown is an extra cost option. CalreC Putting Sound in the Picture...
INTERFACE UNIT lengths table when planning this and discuss the lengths being provided with Power DVD ROM Power the Calrec project engineer involved with Reset your console. CF / MD The Processing rack has a fan tray built ZN5526 ZN5526...
4 x 24V 600W PSU 48dBA Two 24 V Auxiliary outputs are provided 5 x 24V 600W PSU 49dBA via resetable 10 A current trips with LED 6 x 24V 600W PSU 50dBA status indication on the front panel. These 22 Omega with Bluefin...
Should any of the fans slow down or stop, or any voltage rail fall outside specified limits, a PSU Fail signal will be sent to the console and PC to warn the operator of a problem. CalreC Putting Sound in the Picture...
- raCk InterCOnneCtIOns Calrec provide a cable set to inter- The computer touch screen normally re- long interconnections may occasionally connect the control surface and the quires a local mains supply to the control require additional power supplies near to processing racks.
Page 25
REAR VIEW OF ALL UNITS (NOT TO SCALE) OMEGA RACKS J120 J101 DEBUG 2 DEBUG 1 9M D-TYPE 9M D-TYPE J113 J108 J121 J103 AES4- AES3- AES2- AES1- #1-16 #1-16 #1-16 #1-16 FAST LINK J100 RJ45-8V J122 J111 005-01 J102...
LAN. Usernames and Passwords It is recommended that this user is used Calrec will not be responsible for the The PC will initially be set up with two sets during configuration of the PC and the...
(such as saving even if not edited). If the file needs to be e-mailed to Calrec for any reason it should always be zipped to protect the file time/date stamp. A new backup copy of this file should be made after a console upgrade.
Calrec digital consoles provide SNMP messages from the console’s AWACS fault reporting system. The message sent is the same text that is Setting up SNMP reporting The SNMP server software needs to be displayed when clicking on specific fault configured to process the messages it reports on the AWACS screen.
Interconnections need to be made On the Dolby unit: Repeat the process for all the GPI pins 24 between the Dolby unit and the Omega - 31 (as drawing/spreadsheet) <label> means press the button with the GPIO relays. These are in, and have <esc>...
The talkback microphone connects to the console via the XLR connector on the Broadcast Facilities panel of which the Omega has three alternative versions. The RT5685 shown below left provides not only the broadcast mode controls, but reset buttons and the talkback mic.
Page 33
• Headphone D to A converter • Headphone amplifier • An internal DIL switch to reverse the phase of the right leg of headphone audio (SW4) CalreC Putting Sound in the Picture...
Page 34
50F D-TYPE 50F D-TYPE D37F-SP-PF METER DATA FAST LINK RS422#2 RS232 9M D-TYPE 50F D-TYPE 50F D-TYPE RJ45-8V RJ45-8V RJ45-8V GPI #3 GPI #4 RS232 DEBUG#2 RS422#1 DEBUG#1 9M D-TYPE RJ45-8V RJ45-8V RJ45-8V HN5637 CONSOLE INTERFACE 3 Omega with Bluefin...
Function column. Only the serial functions which flashes when a valid message is the system. which are enabled for the console will be received from the user serial port. available for selection. CalreC Putting Sound in the Picture...
BNC (75Ohm) over a coaxial AND optical medium and JM5450 DC (24V) SC - Multi-mode BNC (75Ohm) receive over a coaxial OR optical medium. JM5451 AC (100-240V) SC - Multi-mode BNC (75Ohm) A switch allows receiver selection. 3 Omega with Bluefin...
IT technology, but an integral part of • Status representation of all devices configurable I/O may be connected onto the Calrec audio system. It is therefore on the network the network, providing remotely located normally quoted and supplied as part of •...
The above diagram shows 4 control Synchronization Local I/O 3051-31- rooms, each with a Calrec digital con- Consoles sharing sources must be Local I/O in the console’s own racks sole. The Gigabit interface unit for synchronized (e.g. to station sync or video).
Alpha and Sigma systems can have up Gigabit port on the unit is not used. The own unique IP address, which the system to 8 WAB interfaces; Omega and Zeta unit runs at Gigabit speed all the time, and uses to identify each network connection.
Mode devices are connected to it, and routes data to the correct destination port. It is It is for this reason that Calrec do not restrictions, the redundant PSU must capable of continuously receiving data at warrant our products for any Hydra...
As standard, one IEC input connector is fitted to power both internal PSUs. The units incorporate a cooling fan Optionally, a second IEC can be fitted module. Each PSU module and the fan to allow a unit to be powered from 2 Omega with Bluefin...
Page 43
Calrec SDI boxes come in two dif- ferent versions one for use with HD 4 SDI IN & PASS THROUGH (VI5672) (high definition video) and the other for SD (standard definition). As with the analog and AES-3 boxes, these SDI interfaces connect to the network via an Ethernet port on the rear of the unit.
Page 44
RS232 port is provided, such that system networks together. Status (x 8 red) diagnostics can be performed by a Calrec approved engineer. Connection to the If a Hydra I/O box needs to be swapped In addition, each input connector has...
M allowing a twelfth input or output networking system to one or more module to be fitted into slot L. Earthing Calrec digital consoles. The box is fitted with an external earth Ground Lift Switches stud on the rear, for connection to an...
Page 46
(50 mm) from the fans and rear air outlets, and also any walls or other Modular Hydra I/O Box 35.2 surfaces. (Fully Populated) Optional Rack Mounted PSU 15.6 (with 2 plug-in units) Optional Rack Mounted PSU 25.3 11.5 (with 4 plug-in units) Omega with Bluefin...
Hydra Network using SFP GBICs (Small Form-factor Pluggable Gigabit OPTICAL Interface Converters). These CABLE TYPE CONNECTOR CALREC PART GBIC - HP REF POWER convert the Gigabit Ethernet data DISTANCE BUDGET into light waves using a laser diode Copper CAT...
Page 48
275 m / SX - AFBR - 491-087 7.5 dB Multimode 905 feet 5717LZ Calrec offer 1U rack mounting tray, part Fibre 50/125mm SX - AFBR - EC5453 and this can be fitted with one LC Duplex 550 m / Multimode...
For further information or advice please If streaks or contaminants still remain, contact Calrec. repeat the process using a fresh lens tissue. CalreC Putting Sound in the Picture...
The cable ties should only be tight enough to sufficiently support the cable bundle, and not to deform the outer cable sleeve/jacket. 0 Omega with Bluefin...
Processing Rack belonging which the system’s AES inputs and to that slot are used to connect to the outputs are connected. Each of the equipment being interfaced. connectors provides 16 AES pairs. 2 Omega with Bluefin...
Mic/line inputs use a hand wired cable the same way with the large pin at the top Calrec supplied cables, normally of 1, 3 or assembly of twin and screen cables. The which is the same end of the connector 5 metres but this length can affect pricing.
Inputs - xlr Up to 3 analog input (ADC) cards can The Calrec SN5389 panel has female Each of the input connectors provides be fitted into the processing rack, connectors so the user cables need connections for 4 stereo inputs. The each providing 16 stereo inputs.
16 male XLRs can be numbered 1-3. Each slot has 2 dedi- connected to the DAC connectors on the The Calrec SN5666 panel has male cated output connectors on the rear rear of the rack via MDR cabling.
Ideally the EDAC interface panels within the rack, and each slot has 4 should be located within 5 m (16.5 ft) of rear of the rack via Calrec custom cabling dedicated input connectors on the the Processing rack. rear of the rack, to which the system’s to achieve Style 1 (4 pairs per EDAC).
Page 59
ADC connectors on the dedicated input connectors on the should be located within 5 m (16.5 ft) of rear of the rack via Calrec custom cabling rear of the rack, to which the system’s the Processing rack.
Style 1 - 8 pairs per 38 way EDAC 17 . 35 18 . 36 Chassis On EDACs, the first pin is HOT (phase), the second pin is COLD (anti- phase) and H.LL are chassis connections. 8 WAY EDAC INTERFACE PANEL SN5080 0 Omega with Bluefin...
Page 61
Chassis 18 . 36 Chassis STEREO LINE OPs 19-24 On EDACs, the first pin is HOT (phase), the second pin is COLD (anti-phase) and H.LL are chassis connections. 8 WAY EDAC INTERFACE PANEL SN5080 CalreC Putting Sound in the Picture...
14 . 32 MM.NN Line IP 7R 15 . 33 PP.RR Line IP 8L 16 . 34 SS.TT Line IP 8R 17 . 35 H.LL Chassis 18 . 36 Chassis 8 WAY EDAC INTERFACE PANEL SN5080 Omega with Bluefin...
Need help?
Do you have a question about the OMEGA and is the answer not in the manual?
Questions and answers