Connect Systems CS-700 User Instruction Manual page 8

0.8. Disconnect Code
0 = # Down
1 = # Plus Connect Code
DEFAULT: 0 = # Down
Choose the patch disconnect code. Enter 0 to select # down in most
applications. Or enter 1 to select # plus the connect code digits
that were selected on line 0.6.
0.9. Dialing Mode
1 = Tone
0 = Pulse
DEFAULT: 1 = Tone
Choose how the CS-700 will dial your phone calls. Select tone if
you are in a touchtone telephone exchange, because dialing is much
faster. Note that the CS-700 has fully regenerated touchtone unlike
most other products available.
1.0. Access Delay
Select 1-9 (1-9 seconds)
1 sec increments per step
DEFAULT: 2 = 2 secs
Access Delay is a user selectable delay to compensate for DTMF-PTT
delay built into your mobile DTMF microphone. Select a value that
allows you to hear all of the CW ID and/or dialtone without
clipping.
1.1. Manual Dialing
1 = Enable
0 = Disable
DEFAULT: 1 = Enable
Select 'Disable' if dialing should only be allowed from the
autodialer memory.
1.2. Toll Restrict Digit Counting
1 = Enable
0 = Disable
DEFAULT: 0 = Disable
Enables/disables toll restrict digit counting. If enabled, a number
exceeding ten digits cannot be dialed.
1.3. Prefix Restrict A
0000 = None (display reads ' -')
x - xxxx = Multi Digit Prefix Restriction
DEFAULT: 1 = 'One' Digit Prefix Restriction (Long Distance)
1.4. Prefix Restrict B
0000 = None (display reads ' -')
x - xxxx = Multi Digit Prefix Restriction
DEFAULT: 0 = 'Zero' Digit Prefix Restriction (Operator)
Connect Systems Inc. - Model CS-700
[1.2.]
[1.7.]
Page
8