Panasonic CY-M9054EN Operating Instructions Manual page 13

Fuse
Be sure to use a fuse of the specified rating (20A x 2) when replacing a blown fuse. Fuses with higher capacity
ratings, use of any substitute, or connection without a fuse may result in a fire hazard or damage to the unit. If
the replacement fuse fails, consult your nearest authorized Panasonic Service Center.
Maintenance
To clean the exterior of this unit, use a soft cloth to wipe the surface. Do not use benzine, thinner, or any other
type of solvents.
Specifications
Power Supply
Current Consumption
Speaker Impedance
Power Output ("EIA" Power)
Maximum Power Output
Total Harmonic Distortion
Low Pass Filter
BASS Boost
Signal to Noise Ratio
Frequency Response
Input Sensitivity (Pre)
Input Impedance
Dimensions(W x H x D)
Weight
: DC 12 V (11 -16 V)
Test Voltage 14.4V
Negative Ground
: 24 A (at 45 W x 4)
: 4 Q
: 2-CH; 90 W x 2 (20 Hz - 20,000 Hz, 0.08 %)
3- CH; 45 W x 2 + 90 W (20 Hz - 20,000 Hz, 0.08 %)
4- CH; 45 W x 4 (20 Hz - 20,000 Hz, 0.08 %)
: 2-CH; 200 W x 2
3- CH; 100 W x 2 + 200 W
4- CH; 100 W x 4
: 0.08% (1,000 Hz, at 45 W)
40 Hz - 400 Hz
0 dB -14 dB (Middle Frequency : 60 Hz)
: 105 dB (IHF, A)
: 10 Hz-40 kHz
: 0.15-4 V
: More than 10 kQ
234 x 55.5 x 352 mm
3.7 kg
Note:
Specifications and the design are subject to possible modification without notice due to improvements.
13