Toro BRC-28 Installation Instructions

BRC-28 Lift Frame Kit
Model No. 138-4320
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
1
Installing the Lift Frame
Parts needed for this procedure:
1 Lift frame
4 Side mount bolt
4 Locknut
2 Front mounting bolt
1 Front mount block
1 Lifting eye
2 Flat washer
1 Lock washer
1 Lifting-eye bolt
Procedure
Note:
Discard any removed hardware unless
otherwise directed.
1. Park on a level surface, shut off the engine, and
remove the key.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Lift frame
Side mount bolt
Locknut
Front mounting bolt
Front mount block
Lifting eye
Flat washer
Lock washer
Lifting-eye bolt
PRELIMINARY
Register at www.Toro.com.
Qty.
1
4
4
2
1 Install the lift frame.
1
2
1
1
2. Bend the upper portions of the tie-down sections
on the handle support braces so that they are
nearly vertical (Figure
Figure 1
Left side shown
1. Tie-down
2. Upper nuts
3. Nuts (inside chassis)
Original Instructions (EN) All Rights Reserved *3418-253* A
Printed in Australia
Form No. 3418-253 Rev A
Installation Instructions
Use
1).
4. Handle support brace
5. Bolts
g242155