A Before Applying Power - Kenwood KX-5550 Instruction Manual

Before applying power
*t\
Caution: Read this page carefully to ensure safe operation.
For the U.S.A. and Canada
Important!
Units shipped to the U.S.A. and Canada are designed for
operation on 120 volts AC only.
CAUTION:
TO PREVENT ELECTRIC SHOCK DO NOT USE
THE AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE' BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240
volts AC only.
The mains plug must be removed from the wall socket prior to
any internal examination.
The wires in this mains lead are coloured in accordance with the
following code:
Blue ....Neutral
Brown... Live
The wires in this mains lead must be connected to the terminals
in the plug as follows:
Wire colour Plug terminal marking
Blue.. N or Black
Brown......L or Red
fuse.
2. !f a 3-pin plug with earthing contact is used, no wire must be
connected to the E terminal.
For Australia and Europe
Important!
Units shipped to Australia are designed for operation on 240 V AC
only.
Units shipped to Europe are designed for operation on 230 V AC only.
For other countries_
Important!
Units shipped to countries other than the above countries are equipped
with an AC voltage selector switch on the rear panel. Refer to the
following paragraph for the proper setting of this switch.
AC voltage selection
This unit operates on 110 -120 or 220 - 240 volts AC. The AC voltage
selector switch on the rear panel is set to the voltage that prevails
in the area to which the unit is shipped. Before connecting the
power cord to your AC outlet make sure that the setting position of
this switch matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
Note:-
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
1. Before plugging in this unit, make sure that the position of the AC
Voltage Selector conforms to your line (mains) voltage. If not, it
must be reset. See Figure 1.
2. To reset the selector, slide the stopper plate to the opposite side
with a screwdriver or other pointed tool. See Figure 2.
3. Insert the power cord securely. See Figure 3.
Safety precautions
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
A
1 CAUTION 1 A
'CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER¬
VICING TO QUALIFIED SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOL¬
TAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE
• TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
i k
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE
USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) IN¬
STRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
KX-5550 (ED
3