17-Cleaning And Maintenance - MCZ PERFORMA 15HQ EASYCLEAN H1 Operation And Cleaning

17-CLEANING AND MAINTENANCE

Disconnect the product from the 230V power supply before performing any maintenance operation.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
If the pellets in the tank run out, unburned pellets may accumulate in the brazier.
Check the status of your brazier every 15 days.
The automatic cleaning system means you don't have to empty the brazier. However, if there are pellets with a very high
ash residue this system may not be enough.
We therefore recommend adjusting the checks to the kind of fuel you are using. Red recommends using A1 class pellets
with an ash residue of less than 0.7%.
REMEMBER THAT ONLY A BRAZIER THAT IS CLEANED CORRECTLY CAN GUARANTEE SAFE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCKOUT STATUS OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE STARTING IT BACK UP AGAIN.
For the brazier to be cleaned properly, remove the ash from its housing and thoroughly clean all the holes and the grate on the bottom.
If you use good quality pellets, you will normally only need to use a brush to restore the component to perfect condition. For tougher
incrustations, use the steel tool provided as standard with the boiler.
40