Custom Brackets RF-PRO M Instructions

Folding the bracket for storage
Upright lock knob
Remove your camera and fl ash prior to storage. It is not necessary to remove a fl ash cord if attached to the fl ash
mounting plate. Loosen the upright lock knob and rotate upright backward to lower until fl at. Fold in the leg.
If upright is in lowest position, rotate the fl ash rotator to its 45 degree position for storage.
Note:
- The upright knob may be tightened when the bracket is in the storage (fl at) position. The upright lock knob must
be loosened prior to rotating the upright or damage may occur and warranty will be void.
Attaching the bracket to a tripod or monopod
Attach the RF-PRO M to a tripod / monopod's 1/4" x 20 threaded mounting stud and tighten until fi rmly attached.
Optional Accessories - Sold Separately
RF-WT
WFM-2
CK-501
(Manfrotto RC2 Series)
Refer to instructions included with accessory for attaching to bracket
USA Lifetime Warranty
International Lifetime Limited Warranty
Bracket in
storage position
Leg (folded in position)
RF-C1
RF-C2
RF-C3
Repair
Maintenance
RF-PRO M (Rapid Fire) INSTRUCTIONS
U.S. Patent 8,774,618
Shown with
short camera
Captive fl ash screw
"D" clip stainless steel
1/4" x 20 thread
Flash rotator
Upright screw
on backside
Flash rotator
base
Backside of
bracket shown
Upright
Captive upright
lock knob
Fold-out leg
Must be completely folded
in or out to rotate fl ash
Parts of the RF-PRO M
phone: 440.810.1199
website: www.custombrackets.com
Made in U S A
email: info@custombrackets.com
Shown with
tall camera
Flash anti-twist (2)
Captive
Clamp knob
Manfrotto RC2 Series
camera quick release clamp
Tripod hole
1/4" x 20 thread
Connector Mounting Hole
For accessories RF-C1, RF-C2, RF-C3