Table of Contents
Advertisement
b.
amono microphone for mono recordings.
In both cases adjust the recording level with control (29).
Notes:
1. Telephone coil N 6708 is connected in the same way asa
mono microphone.
2. The microphone leads can be extended by means of
connection/extension lead 4822 321 20211.
When the equipment to be connected is not provided with a
connecting lead with plug, use stereo connection lead
EL 3768/14.
For connection to equipment not fitted with DIN con-
nections, adapter leads and plugs are available.
"TAPE" (26) under shutter 23), intended as temporary
connection facility.
Socket for record player "PHONO" (47) (input)
Selector (49) for "PHONO" socket (47)
"DYN": in this position the "PHONO" socket (47) is
suited for record players with a Hi-Fi pick-up cartridge (dy-
namic or ceramic) without built-in preamplifier.
" AUX" socket (48) or one of the "TAPE" sockets (26 or
50).
Connection socket for tuner "TUNER" (51) (input)
For connection of a tuner. Normal radios and tuner/am-
plifier combinations must be connected to one of the "TAPE"
sockets (26 or 50) (input/output) or the "AUX" input (48).
64
Auxiliary socket "AUX" (48) (input)
For connection of other than the usual input sources, e.g. an
electronic organ or an electric guitar. However, first check
that the output voltage of the apparatus to be connected
and the input sensitivity of the "AUX" input correspond.
The input may also be used to connect a normal radio set, a
tuner-amplifier combination (receiver) etc. Record players that
may be connected to the "PHONO" socket (47) in position
"CRYST" of switch (49), may also be connected to the
"AUX" input socket. Switch (49) operates the "PHONO"
input (47) only.
Connection socket for monitor amplifier "MONITOR"
(46) (output)
For connection of a monitor amplifier. The socket always
supplies a signal, both during playback, recording and when
using the amplifier section. This allows it to be used for
connecting another tape recorder (duplicating) or an external
(monitor) amplifier. (During recording and when using the
amplifier section the "TAPE" outputs (26 and 50) are
blocked.)
b. with the protrusion on the plug tumed half a turn (180°)
further than under a.: the loudspeaker enclosures remain
switched on.
Socket for remote control "REMOTE" (43)
3. RECORDING
3.1. USING MICROPHONES
Advertisement
Table of Contents
