Advertisement
Remove all packaging including any press plate protection before using your handheld garment steamer.
Before connecting your handheld garment steamer to the mains supply, make sure your supply voltage is the same as the one indicated on your appliance.
When you first use your handheld garment steamer, there may be a slight odour and it may smoke slightly for the first few minutes of operation. This is quite normal and will disappear.
Your appliance has been designed to use tap water. If your water is very hard, mix 50% tap water and 50% bottled demineralised water.
Never add fabric conditioner, starches or any other chemicals to the water in your handheld garment steamer.
Always unfold the steam head until it is locked before any use of the appliance.
Follow these simple steps to remove any impurities or residues inside your handheld garment steamer that may be left over from the manufacturing process.
Never use steam on silks or synthetics.
Note: Before first use or if the handheld garment steamer has not been used for a long period of time, it will be necessary to prime the appliance. See 'Cleaning your handheld garment steamer before use' for instructions.
Warning: Allow the appliance to completely cool down before folding for storage. Take care not to pinch or trap hands, fingers or the power cable when folding the head of the handheld garment steamer.
Your handheld garment steamer comes with a fabric brush and travel pouch.
Make sure the handheld garment steamer is unplugged and cool before applying attachments. If the unit has been in use, allow the unit to cool down completely first before changing attachments as the press plate will still be hot.
Do not use harsh abrasives, chemical cleaners or solvents to descale of your handheld garment steamer.
We advise you do this operation in a vented room.
If you notice a decrease in the performance of your appliance, it may need descaling. Descaling helps to removes scale and impurities to prolong the life of your appliance. If the water in your area is very hard, the descaling should be performed more frequently.
Do this process in a well-ventilated room.
Do not use harsh abrasives, chemical cleaners or solvents to clean the exterior of your handheld garment steamer. Do not immerse the appliance or power cord and plug in water or any other liquid.
Allow your handheld garment steamer to completely cool down and wipe the press plate and exterior with a soft damp cloth. Wipe dry before storing.
In the case the appliance does not operate but is under warranty, return the product to the place it was purchased for a replacement. Please be aware that a valid form of proof of purchase will be required. For additional support, please contact our Consumer Service Department at 0800 028 7154 or email: BrevilleEurope@newellco.com.
For troubleshooting and FAQs visit www.breville.co.uk/faqs
Problems | Possible Causes | Solutions |
There is no steam. | The appliance is not plugged in, or not switched on. | Check that your appliance is correctly plugged in and switched on. |
The appliance is preheating. | Once the appliance is plugged in and switched on, wait approximatively 40 seconds for steam to be available. | |
The water level is too low. | Unplug your appliance and refill it. | |
The steam pump has not been primed. | Refer to the 'Priming your handheld garment steamer before use' section. | |
You are using the appliance for the first time. | Refer to the 'Priming your handheld garment steamer before use' section. | |
The water tank is not fully in place. | Ensure that the fill inlet cover is closed and that the water tank snaps when put into place. | |
Steam trigger cannot be pressed. | Completely unfold the steam head until locked to allow the steam trigger to be pressed. | |
There is noise emitting from the appliance. | The water level is too low and the pump is pulling air. | Unplug your appliance and refill it. |
The appliance is heating up. | This is normal when the appliance is heating up. | |
The appliance does not heat. | The appliance is not plugged in, or not switched on. | Check that your appliance is correctly plugged in and switched on. |
Water tank leaks. | The water tank is not fully in place or the fill inlet cover is not closed properly. | Ensure that the fill inlet cover is closed and that the water tank snaps when put into place. |
Water leaks from the steam head. | The appliance is in a tilted position. | Gently return to an upright position. |
The appliance is not completely unfolded and locked. | Ensure the appliance is completely unfolded and locked. | |
The steam button has been pressed before appliance has finished pre-heating. | Wait approximately 40 seconds for the appliance to heat up. When the power indicator switches on, the appliance is ready to use. | |
Steam rate decreases. | Calc build up. | Refer to the 'Descaling instructions' section. |
The steam leaves stains on the fabric or the appliance spits. | You are using water with additives. | Never add any additive in the water tank. |
The appliance has not been cleaned enough after the descaling operation. | Refer to the 'Descaling instructions' section. | |
You are using other liquids than white vinegar to descale the product. | Use only white vinegar during descaling operation. |
This appliance must be earthed.
If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type.
If the fuse in a moulded plug needs to be changed, the fuse cover must be refitted. The appliance must not be used without the fuse cover fitted.
If the plug fuse requires replacement, a fuse of the same rating as that fitted by the manufacturer must be used. In order to prevent a hazard do not fit a fuse of a lower or higher rating.
If the terminals in the plug are not marked or if you are unsure about the installation of the plug please contact a qualified electrician.
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Keep the appliance and its cord out of reach of children less than 8 years old when it is switched on or cooling down.
The appliance must not be left unattended when it is connected to the mains supply.
The appliance must be unplugged from the mains supply socket before filling the water tank with water.
Always use the appliance on a stable, secure, dry and level surface. When placing the appliance on its stand, ensure that the surface on which the stand is placed is stable.
Do not use the appliance if it has been dropped, if there are any visible signs of damage or if it is leaking. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Never use this appliance for anything other than its intended use. This appliance is for household use only. Do not use this appliance outdoors.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Breville VIN430 - CompactSteam Handheld Garment Steamer Manual
Advertisement
Need help?
Do you have a question about the VIN430 and is the answer not in the manual?
Questions and answers