Advertisement
Installing the audio unit on the wall
1
Attach the safety wires to the Attachment.
Attach the safety wires as
shown in the figure on the
right.
2
Installing the audio unit on the wall.
Hang the audio unit by hooking the mounting
holes on the upper part of the Attachment onto
the screws in the wall.
3
Attach the safety wires to the wall.
Pass the screws (commercially
available) through the washers
(supplied), and then through the loops
on the end of the safety wires, and
tighten the screws into the wall to
secure the safety wires while
removing any slack of the wires.
Notes
• Make sure that the screws are strong
enough to bear the weight of the audio
unit and the Attachment in case they
fall.
• Choose a secure wall or beam to fasten
the screws.
Notes
• After installation is complete, make sure that the audio unit is securely affixed. Yamaha is not responsible for any accident
caused by inappropriate wall conditions or inadequate installation.
• Be sure to secure the cables so that they will not be caught by feet or hands, possibly causing the audio unit to fall.
4
En
Washer
(supplied)
Screw
(ø6 mm;
commercially
available)
Safety wire
Slip one end through
the loop at the other
end
Advertisement
