Table of Contents
Advertisement
15 Basic settings
You can configure the basic settings for your appliance to meet your needs.
15.1 Overview of the basic settings
Display
Setting
Childproof lock
Signal tones
Automatic switch-off of the cooking zones.
Duration of the timer end signal tone
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit,
played and you cannot select a higher power
level.
Time for selecting the cooking zone
Cookware test
You can use this function to test the quality
of the cookware.
Set circulating-air mode or air extraction
mode.
Setting automatic start
Setting the run-on
If your hob is working in air extraction mode,
the ventilation system is switched on at the
power level for approx. 6 minutes.
If your hob is working in circulating-air mode,
the ventilation system is switched on at the
power level for approx. 30 minutes.
The run-on function automatically switches
off after this time.
Restoring factory settings
1
Factory setting
15.2 To go to the basic settings
Requirement: The hob must be switched off.
Value
1
- Manual.
Automatic.
– Switched off.
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
– switched off.
-
- minutes until the appliance switches off auto-
matically.
– 10 seconds
– 30 seconds
- 1 minute
- Switched off. Maximum power of the hob
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
is dis-
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
- Unlimited: You can adjust the last selected cooking
zone without having to select it again.
– Limited: You can adjust the last selected cooking
zone within 10 seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
- Not suitable.
- Not optimal.
- Suitable.
- Configure circulating-air mode.
- Configure air extraction mode.
- Switched off.
– Switched on.
- Switched off.
- Switched on
- Individual settings
- Factory settings.
1.
To switch on the hob, touch
2.
Within the next 10 seconds, touch and hold
four seconds.
1
.
1
1
1
1
1
1
:
1
.
.
Basic settings en
1
.
for
13
Advertisement
Table of Contents
