Pioneer PL-L1000 Operating Instructions Manual page 4

3. Remove the tonearm hold<!r 8 from the tonearm base.
'---Toneerm
t..lst
STEP 5: REMOVING TRANSIT SC REWS
Remove three transit
scn~ws
with
a
Phillips
scn~wdriver
as
shown below.
ii'I---"T
rensft
ICt'IW
®
I
..
STEP 6: MOUNTING THE PLATTER AND
RUBBER PLATTER MAT
1. Slip the platter over the center shaft and secure it using
the accessory platter clamp screws (3) and an ordinary
slot screwdriver.
2. Place
me
rubber platter mat on top of the platter.
Plttttr c•mp-- --._
SCfiW
Ctnttr shift·
4
STEP 7: MOUNTING THE HEADSHELL
lnottll the certridge as d tseribld on
page 5
" ATTACHING
THE CARTR IDGE" and attiCh tht hudshell to tho to no·
arm
H
follows:
Insert t he headshell into the end o f the tonearm, and rotate
the locking collar In the direction Indicated by the arrow in
the figure until it stops. Then secure it.
STEP 8: MOUNTING THE COUNTERWEIGHT
Slip the small size counterweight onto the
trackin~tforce
scale ring at the end of the tonearm.
Next,
adjust the
position of t he weight so that the clearance between the
weight and the tracking-force
SC4Io
ring comes to 0·\mm
(depending on t he weight of the cartridge, It may be
better to vary this clearance slightly),
Rotate tht screw with tha accessory screwdri•tr and t ighten
It
socurtly.
NOTES'
0-1mm
,.j::t-.,.,.-_.---
CountlfWOight
/ '- - Treckl"!!·force
ICIIt ring
• If you p4an to
U N •
c:41rtrid" wtlfhlnt
fY'IOtt
th• n 14f ltuch u
tht Ortofon SPU/GT). mount thl KCHIO"V
llflllizl
count.,•
wt itht.
• Not• thlt the proper tracklne f orot
adjunment
can not be
Mt
unlm tht count trwt iQht iaMcu,.ly and correctly intt.lltd.
STEP9: MOUNTING THE DUST COVER
To install, insert the hinge> of the dust cover into the hinge
sockeu of the cabinet, and push tht dust cover downward.