Advertisement
Quick Links
.66 Assembly Instructions
This is a guide to help you assemble your new
.66 cockpit system at home.
Some assembly steps require specific tools and
saftey equipment. These steps will be marked by
a hazard symbol.
If you do not have the correct equipment, please
get your local bike shop to help.
drag2zero.co.uk
+44 (0)1295 236117
info@drag2zero.com
Advertisement
Related Manuals for Drag2Zero .66
Summary of Contents for Drag2Zero .66
- Page 1 .66 cockpit system at home. Some assembly steps require specific tools and saftey equipment. These steps will be marked by a hazard symbol. If you do not have the correct equipment, please get your local bike shop to help. drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
-
Page 2: Tools Required
2 x grips Tools required T10 torx key T25 torx key 6mm allen key 5mm allen key (if your bike has M5 bolts) Threadless Saw Guide Fine tooth hacksaw Eye protection High quality face mask drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com... - Page 3 Pole clamps end ii 20mm spacers vii Pole clamp top spacer viii 1mm spacer i Pole clamp to shim spacer iii 10mm spacers iv 5mm spacer v 2mm spacers Pole grip end vi Pole profiled spacer drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 4 Thread di2 through central slot. Tools required: 6mm allen key * If you have ordered risers with your kit, make sure bolts protrude underside of riser by 6mm as shown in the image to the right. drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 5 Measure 20mm down from Step a marked line. c. Cut pole end to marked line in Step b using Threadless Saw Guide. * Tools required: Threadless Saw Guide Fine tooth hack saw Step: b Eye proetction High quality face mask Step: c drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 6 - 6 degrees of toe: 0 degrees of toe: + 6 degrees of toe: 0 degree toe: C1 = C2 +6 degree toe: A1 = A2 E1 = E2 C1 = C2 A1 = A2 drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 7 Not positions of parts and mark 5mm back from the rear of the clamps. This will be the cutline for the pole. Not once cut you reach will be limited to the one set up. drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 8 Place vii pole clamp top spacer found in finishing kit J onto top of pole clamp. Step 11 Find preferred position of armrests on clamps and tighten to 2Nm. (parts: G, 6) Tools required: T25 torx key drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
- Page 9 Step 12 Fit foam onto armrests . (parts: 7) Step 13 For grip installating please refer to our Installation help page and your relevent grip. https://drag2zero.co.uk/installation- help/?v=79cba1185463 Tools required: T10 torx key drag2zero.co.uk +44 (0)1295 236117 info@drag2zero.com...
Need help?
Do you have a question about the .66 and is the answer not in the manual?
Questions and answers