Connecting The Antenna; Input Selector; Input Mode; Auto Sound - Kenwood VR-209 Instruction Manual

input mode settings °
You must select beforehana which type of inout 1s to be used for each
connected component. The initial factory setting is to use the digital
Connecting
Antenna terminal connections
@ Push fever. @ Insert cord. © Return lever.
audio signa! for playback
INPUT SELECTOR
INPUT MODE
ee
@ Press the INPUT MODE key.
Each press switches the setting as follows:
~~ @ D-AUTO (digita! input. auto sound)
@ D-MANUAL (a-gita! inout. manual sound)
— @ ANALOG (anaiog input. manual sound)
|
i
|
| Digital input:
| Analog input:
Select this setting to piay analog signats from a cassette deck
VCR.
| er turntable.
; Auto sound:
In the auio
sound moae
{AUTO SOUND
indicator ights). tne
receiver selecis tne listening mode automatically during playback
ic match tne type oF input signal (Dolby Digitat. PCM. ete } and the
| speaker setting Tne initia! factory setting is auto sound on.
Ta keep the receiver set tc the currently selected listening mode.
; use tne INPUT MODE key to select "~D-MANUAL' (manual sound}
| However. even when thrs setting is selected. tnere may be cases in
which tne listening mode is selected automatically "= maich a Dolby
Digital Source signa! depending on the combinatior of : Sering |
| mode ana source signa!
i
VA-208/208/K RF ¥8010DV75 10D (En/KM}
the antenna
—_ ha
st
a:
AM Ioop antenna
The supplied loop antenna is for use indoors Place it as tar as possible
from the recetver, TV set, speaker cords and power cord, and adjust the
direction for best reception.
FM indoor antenna
° j : :
sass eoncees coe |
Se009000000 || OOO |
—
antenna
D
FM outdoor antenna
Use an antenna
adaptor
(Commercially
available}