Advertisement
3. SPECIFICATION
Model No ........................................................ 1000E.V2
Capacity ............................................................. 1000kg
Maximum Saddle Height .................................... 885mm
Minimum Saddle Height ..................................... 180mm
Overall Width/Length: ................................ 650/1080mm
Saddle Tilt - Backward: .............................................22°
Saddle Tilt - Forward: ................................................25°
Saddle Tilt - Side-to-Side: .........................................12°
4. PRE-USE CHECK LIST
4.1.
NOTE: Before each use, check that the jack is in sound working order, use following list to form a habitual pre-check procedure.
Check items are not: damaged, broken, cracked, bent, malfunctioning, distorted, worn, loose, leaking, dirty, noisy or missing, or
that there is any damage to the welds.
1. Saddle attachments
2. Saddle base
3. Saddle tilt controls
4. Tilt mechanism
5. Piston rod
WARNING! DO NOT use jack if any suspect part is found, or if believed to have been subjected to abnormal load or shock.
‰
Immediately remove from service and contact your authorised service agent.
NOTE: Before using the jack for the first time, purge the hydraulic circuit in order to eliminate any air that may have accumulated in the
system during transit, as follows:
4.1.1.
Open the release valve by turning the knob anti-clockwise.
4.1.2.
Pump the jack handle up and down 15 to 20 times.
4.1.3.
Turn the release valve clockwise to close it.
1000E.V2
1000E.V2
5. OPERATION
5.1.
SADDLE TILT MECHANISM.
5.1.1.
Adjusting the pitch and tilt of the saddle will assist in safely supporting and transporting the gearbox. The saddle (figs.1 & 2.C) may
be tilted forwards and backwards by turning adjuster (figs.1 & 2.A) and tilted to the left or right by turning adjuster (fig.2.B) for model
1500E.V2, or the adjusters and bolts (fig.1.B & D) for model 1000E.V2.
WARNING! Before use, ensure you have read, understood and apply Section 1 safety instructions.
‰
WARNING! Ensure that the vehicle is prepared correctly before attempting to use the Transmission Jack.
‰
5.2.
POSITIONING THE JACK BENEATH LOAD
5.2.1.
Before use, check to ensure that the transmission's weight and size do not exceed the capacities of the jack.
5.2.2.
Ensure that the vehicle from which the transmission is to be removed is correctly positioned, raised and locked on an appropriate lift
system.
5.2.3.
Ensure that there are no other persons around or under the vehicle.
5.3.
Ensure saddle is in it's lowest position, and use the handle to transport and centrally position jack beneath the vehicle's transmission.
© Jack Sealey Limited
6. Cylinder/Hydraulic unit
7. Stopper rings and cotter pins
8. All nuts and bolts
9. All seals
10. Jack main frame
fig.1
Original Language Version
Model No:.................................................................1500E.V2
Capacity:.......................................................................1500kg
Maximum Saddle Height:..............................................950mm
Minimum Saddle Height:...............................................215mm
Overall Width/Length:...........................................655/1100mm
Saddle Tilt - Backward:........................................................15°
Saddle Tilt - Forward:...........................................................10°
Saddle Tilt - Side-to-Side:....................................................12°
11. Pump handle
12. Swivel caster wheels
13. Ring chain, hooks & pins
1500E.V2
fig.2
1500E.V2
1000E.V2,1500E.V2 (H,F) Issue 2 11/05/23
Advertisement
