Locating The Room Unit - Hitachi ATW-RTU-01 Installation And Operation Manual

Installation and Operation Manual
6

2.2.3 Locating the Room Unit

While still in the Test Mode, as described in section 2.2.2, the Room Unit should be located taking the
following into consideration and reviewing the illustrations below:
1. Find a suitable location where the signal transmission is reliable. Reliable transmission is indicated when
the RF Receiver is flashing the green LED every 5 seconds. NOTE : The RF Receiver will be off.
2. Install the Room Unit EITHER on the wall using the wall bracket OR attach the optional table stand as
shown in below.
3. Exit the Test Mode by pressing the
• The Room Unit should be installed in an open space for best performance as it is a radio frequency device.
• Leave at least 30cm distance from any metal objects including wall boxes and at least 1 metre from any other
electrical equipment eg. radio, TV, PC etc.
• Do not mount onto metal wall boxes. • It is recommended that the RF Receiver is fully installed.
or button.
Wall bracket Table stand