Advertisement
3. Adjust the angle of the ADF.
Loosen the two securing screws forthe angle adjusting panel attached to
the hinge angie and then fasten the loosened screws while raising the
angle adjusting panel completely.
Angle adjusting panel
securing screws
Long hole
i (
NOTE:
Besuretocheck thatthe protrusion oftheangle adjusting panelissecurely
inserted into the long hole of the hinge.
4.Connectthe ADF connector.
Remove the connector cover securing screw to remove the connector
cover from the copier's rear cover.
Next, connect the ADF connector to the connector on the copier, and fas-
ten the screw on the ADF connectorcompletely.
Securing screw
Connector cover
5. Connectthe ADF tray connector.
Thread the M4 x8 tray securing screws (included parts) part way into their
holes, thenconnectthe tray connector.
Tray connector
|
LE
Tray
-*<
securing
</
f
screws
/
foam
Connector on the ADF
6. Attach the ADF tray.
Loosen the two ADF tray securing screws, install the tray as shown in the
figure, and fasten the tray securing screws.
Tray |
securing
screws
Plug the copier into a grounded outlet and turn on the power switch. Then
follow the procedure below.
7. Adjustthe center of the copy.
Setan original inthe ADF tray and make acopy.
Whenthecopyisoffcenteras showninFig. 1 orFig. 2, loosen
the two tray
securing screws and adjust the tray by moving it in direction A or B as
shown in the figure below.
Mark
Tray securing screw
8.Setthe mode.
© Setthe mode with the key operation of the copier.
©-8-©-@-m--(%}-co-(29]
Clear
b
>
Press the corresponding
=
'
F
operation key on the display.
@ ee
ses ine
Advertisement
