Pioneer TX-1320Z Operating Instructions Manual page 10

NAMES AND USES OF PARTS
Tuner
@
@ PIONEER ewam piaiTaL SYNTHESIZER TUNER TX-1320Z
FMIIODETUNIN| 3 MODE
STATION cath
[el ellos
@) STATION CALL switches
These are used to recall preset broadcasting stations and to preset the
stations.
(2) MEMORY switch
This switch is used to memorize stations. When the switch is pressed,
the frequency indicator will flash. To memorize the frequency of any
station, press STATION CALL switch while the frequency display is
flashing.
3) BAND selector switch
This is used to select the band of the desired station.
FM: Press to receive FM broadcast.
AM: Press to receive AM broadcast.
(4) TUNING switches
These are used to locate the stations.
Push ''—'' switch to go to a lower, and '' +-"' switch to go to a higher
frequency.
() STEREO indicator
This lights when a stereo program has been picked up during an FM
broadcast.
(6) TUNED indicator
This lights to indicate when the finest tuning of a station has been
achieved.
@) FREQUENCY display
Permits reading the received frequency at a glance from the displayed
figure.
The FM band is indicated by MHz, and the AM band by kHz.
(8) FM MODE (AUTO/MONO) switch
Normally this is set to the off position (the fm MONO indicator goes off).
When noise spoils the reception of an FM Program, press the switch
to the on position (the fm MONDO indicator will now light). The program
of an FM stereo broadcast will be heard in mono. The setting of FM
MODE switch (on or off) is memorized along with the station's
frequency in STATION CALL switches.
When using the preset tuning feature, reception will be in the mode
selected when the station was memorized. This switch will not function
for AM reception.
(When the auto tuning mode is selected, the AUTO indicator will now
light.)
AM/FM CHANNEL STEP SWITCH
The AM/FM channel step switch is located on the rear panel of the
digital synthesizer tuner. Before the Tuner leaves the factory, this
switch is set to the channel allocation system of the area in which
the tuner is sold. When TUNING switch is pressed, the frequency
display will change in the following way.
NOTE:
If the switch is set to the wrong position, correct tuning will
not be possible.
Consult your dealer if you are not sure about the channel allocation
system in your area.
; F hh:
Model destination CHANNEL STEP sh acl Ma CHANNEL STEP
switch position FM mode | AM mode
North America and 50/9 100/10
Continental South | 100 kHz/ 10 kHz | 100kHz 10kHz kHz kHz
America
Other countries 50 kHz/ 9 kHz 50kHz 9kHz
cen SRN eee
10
<ARB1244>