Transport, Such As When Moving Out - Bosch Nexxt 100 Series Operating, Care And Installation Instructions Manual

Secure the connection point with
the clamp and tighten.
Standpipe Installation
Use the elbow. Attach the elbow
to the end of the hose and insert
end of hose into standpipe.
Use a strap or cable tie to hold
hose in place.
In-Wall Installation
Use the elbow. Attach the elbow
to the end of the hose and insert
end of hose into wall drain.
Use a strap or cable tie to hold
hose in place.
Drainage into a siphon
Drainage into a sink
Ensure that the plug is not in the
drain hole.
Attach water drain hose securely
to sink.
Use a strap or cable tie to hold
hose in place.
When the water is being drained,
check that the water flow out of
the sink is adequate.
Transport, such as when
moving out
Before transporting the washing
machine:
- Turn off the water.
- Disconnect the washing machine
from the power outlet.
- Dismantle the supply and drainage
hoses.
- Install the transport bolts.
[_ Having transported the appliance
and ensured proper installation
and connection, allow the Drain
program to run through before
starting the first wash program.
Preparing and inserting the
transport bolts
Remove the covers.
Prepare the transport bolts:
Loosen the screw in the sleeve
until the end of the screw is level
with the end of the sleeve.
Insert and tighten all transport
bolts. Make sure that the tab on
the transportation bolt is inserted
in the slot on the washing machine
back panel.
Secure the connection point with a
hose clip(not included in
factory-supplied equipment).