Page 1
Form No. 3463-725 Rev A Deck Bracket Kit Groundsmaster ® 3200 or 3300 Series Traction Unit Model No. 147-0090 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. –...
Page 2
Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Engage the parking brake. Lower the attachment. Shut off the engine and remove the key. g444222 Figure 1 Right lift arm shown 1. Bolt 3. Right lift arm 2.
Page 3
Installing the Deck Channels Parts needed for this procedure: Hex-head flange bolt g444224 Flange nut Figure 4 Deck channel 1. Existing large bolt 2. Washer Hex-head bolt Washer Mark the 2 bolt-hole locations in the deck tube and use an drill bit (11/32 inch) to drill through the marked deck-tube holes.
Page 4
g444226 Figure 6 1. Hex-head flange bolt 2. Flange nut Torque the hex-head bolt (shown in Figure to 271 N∙m (200 ft-lb). Note: You do not need to use a backup wrench, as the deck channel holds the shoulder-bolt hub and keeps it from rotating.