Sony CMT-HPZ9 Operating Instructions Manual page 35

To save a tape permanently
To prevent a tape from being accidentally recorded
over. break off the cassette tab fiom side A or B as
illustrated.
Break off the
cassette tab
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Other_ ise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastk:. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape mW get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads al'ler c'_ery 10 hours of use.
Be sure to clean the tape heads bel\wc you start an
important recording or after playing an old tape.
Use a separately sold dry4ype or wet4ype cleaning
cassette. For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the mclal parts that
ha; e contact with the tape al]er every 2(1to 30 hours of
use with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
Main unit (HCD-HPZ9/HCD-HPZ7)
Amplifier section
For the United States model
AUDIO POWER SPECIFICATIONS
HCD-HPZ9
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6-ohm loads, both channels driven, l]'om
120 - 10.000 Hz: rated 85 watts per channel
minimum RMS power, with no more than 10%
total harmonic distortion from 250 milliwatts to
raled output.
HCD-HPZ7
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6-ohm loads, both channels driven, fi'om
120 - 10.000 Hz: rated 50 watts per channel
minimum RMS power, with no more than 10%
tolal harmonic distortion fi'om 250 milliwatts to
rated output.
HCD-HPZ9 for CMT-HPZ9
North American model:
Continuous RMS power output (reference):
85+85W
(6ohms at I kHz, 10%
THD)
Other models:
The lbllowing measured at AC 240 V, AC 220 V or AC
120 V
DIN power output (rated): 53 + 53 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
70 + 7(} W
(6ohms at I kHz, 10%
THD)
-,,I
-,,I
HCD-HPZ7 for CMT-HPZ7
North American model:
Continuous RMS power output (reference):
50 + 50 W
(6ohms at I kHz, 10%
THD)
European model:
DIN power output (rated): 50 + 5(1W (6 ohms at
1 kHz, DIN)
continued
35G8