Disassembly - Sanyo VHR-279E Service Manual

1. DISASSEMBLY
REMOVING THE CABINET PARTS (Fig. 1-1-1)
2. Remove the front panel by removing the locks of the clamps
(A) using a screwdriver, etc. and slightly rotating the bottom
part in the direction of the arrow.
Notes: « Electrical adjustments for the this model can be
performed with only the cabinet removed.
M-SE2V/E2-1
REMOVING THE MECHANISM MAIN UNIT AND THE
CP-1 PWB ASSEMBLY (Fig. 1-1-2 and 1-1-3)
After removing the cabinet parts, remove the mechanism unit
and the CP-1 PWB assembly connected as follows.
1. Remove the five screws (2) as shown in Fig. 1-1-2.
2. Remove the two screws (3) at the CP-1 board, and then
disconnect the bottom cover.
Remove the two screws (4) and two screws (5) of the
mechanism unit. The two screws (5) of the cassette tray
can be removed easily by pushing the lid opener lever in the
arrow direction to remove the lock as shown in the enlarge
view.
Lift up the whole mechanism unit and main board (CP-1
PWB assembly), and as shown in Fig. 1-1-3, so that they
can be removed from the chassis.
3.
Fig. 1-1-1