Table of Contents
Advertisement
Quick Links
LED indicator /
REC
Lanyard
USB-C
Reset
Microphone
On/Off Button
hole
port
button
Disclaimer
Atto Digital cannot be held responsible for any use of the TileRec VoiceRecorder
without the necessary permission(s) needed for recording. The user is directly
responsible for researching and obeying the applicable laws.
Please check the local laws applicable in your area. Regardless of whether state or federal law
governs the situation, it is almost always illegal to record a phone callor private conversation to
which you are not a party, do not have consent from at least one party, and could not naturally
overhear. ATTO Digital can't be held liable for any loss or damage of whatever nature (direct,
indirect, consequential, or other) which may arise as a result of aperson's use of (or inability to
use) our products.
Advertisement
Table of Contents
Summary of Contents for aTTo Digital TileRec
- Page 1 ATTO Digital can’t be held liable for any loss or damage of whatever nature (direct, indirect, consequential, or other) which may arise as a result of aperson’s use of (or inability to...
- Page 2 A comprehensive guide to help you set up and make the most out of your TileRec . Follow this for initial setup, best practices, and troubleshooting tips. Two convenient lanyards are included for easy portability. Attach these to the lanyard hole on your TileRec to carry it around your neck or secure it to other objects.
- Page 3 Setting up the recorder A. Setting Time Stamp Connect the recorder to a PC via the USB-C cable provided in the box. *If the computer has a USB port, conect the cable directly to it. If the computer has a USB-C port, use the USB-C adapter in the box to connect the cable.
- Page 4 A. Connect to a computer with USB port 1. Make sure your TileRec device is turned off. Slide the REC button to the "OFF" position to ensure the device is off and to make sure that any ongoing recordings are properly saved.
- Page 5 USB device is connected. 6. In the file manager, look for a new drive that represents the TileRec device. This may be listed as 'USB Storage' or similar. Tap on the new drive to open it, and locate the folder named 'RECORD.
- Page 6 1. Playing Back Recordings on Your Computer Connect the TileRec device to your computer using the provided USB-C cable. Insert the USB-C end into the TileRec and the other end into an available USB port on your computer. For Windows: Open 'My Computer' or 'This PC' and locate the new drive that represents the TileRec device.
- Page 7 Here are some troubleshooting steps to consider: 1. Device Not Detected by Computer If you connect the TileRec to your computer and can't see its storage partition, make sure the recorder is turned off before initiating the connection and that you are using a working USB cord that allows data transfer.
- Page 8 Even if you don't use the device regularly, it is recommended to charge the battery at least once every 6 months to prevent over-discharge. By following these troubleshooting tips and care guidelines, you can extend the life of your TileRec voice recorder and maintain its optimal performance. Technical Specification Dimensions: 1.6" x 1.6"x 0.25 “...
Need help?
Do you have a question about the TileRec and is the answer not in the manual?
Questions and answers