Tunturi Air Rower R701 Owner's Manual page 5

3. Slide the seat assembly onto the
seat rail. Be sure the notch in the
seat points to the rear of the rower.
(Refer to illustration #3.).,
. Attach the rear stand tube to the
seat rail.
Align the holes іп the rear stand `
tube with the holes in the bottom of
the seat rail. Use:the 12mm open-
end wrench to secure the rear
stand tube to the seat rail with two
(2) в" х1" hex head bolts and
two (2) %6" lock washers provid-
ed. The bolts thread into the nut
plate placed inside the rear stand
tube. (Refer to illustration #3.)
Push the end cap into the end of
the seat rail. Place an end cap on
each end of the rear stand tube.
Use a Phillips screwdriver to at-
-tach the rear seat carriage stop to
the bottom of the seat rail with one
(1) Phillips head screw and %6"
flat washer provided.
Seat Assembly
Nut Plate
š | = =
Seat Carrlage—o
Stop
5. Attach the seat rail to the main
frame.
Position the seat rail on the mount-
ing bracket of the main frame so
the holes in the mounting bracket
match those in the seat rail. Push
the 3/8" x 51/2" hex head bolt
through the seat rail and mounting
bracket. Use the 15mm open-end
wrench to tighten the hex head
bolt, 3%" flat washer on each side
and locking nut. (Refer to illustra-
Поп #4.) - |
6. Insert locking pin іп the top of the
seat rail and tighten. (Refer to illus-
· tration #4.)
NOTE: The locking pin can be re-
moved to lift the seat гай upright
when moving the rower. See "Тгапв-
portation" later in this manual.
Mounting
Bracket `
7. Feed the electronics cable. (taped
to the seat rail) through the elec-
tronics mounting bracket. Use a
Phillips screwdriver to attach the
mounting bracket to the seat rail
using two (2) Phillips head screws
provided. |
Insert two (2) size AA 1.5 volt bat-
l teries into the electronics module
battery holder. The direction of the
. batteries is indicated inside the
battery holder.
Connect the electronics cable to
the electronics module. Place the
electronics module on the velcro
tabs located on the seat rail. (Refer
to illustration #5.) Press gently to
secure. |
. Attach the handlebar.
Place the handle over the cable
bolt with the larger recessed hole
facing outward. Place а зв"
washer, lock washer, and hex cap
nut on the cable bolt.and tighten
with the 15mm open-end wrench.
Remove the cable retaining plate
and discard. (Refer to part no. 39
on exploded diagram on p. 12).
Electronics
Module
Electronics
Cable |