Spektrum Sr315 Sport Surface Receiver; Typical Electric Vehicle Installation; Typical Nitro Vehicle Installation; Receiver Compatibility - Spektrum DX6C Instruction Manual

EN

SPEKTRUM SR315 SPORT SURFACE RECEIVER

TYPICAL ELECTRIC VEHICLE INSTALLATION

To Motor
Steering Servo

BINDING

The SR315 receivers must
be bound to the transmitter
before they will operate.
Binding is the process
of teaching the receiver
the specific code of the
transmitter so it will only
connect to that specific
transmitter.

FAILSAFE

Failsafe position is set during binding. In the unlikely event
that the radio link is lost during use, the receiver will drive all
channels to its pre-programmed failsafe position.
Standard Mode
If loss of signal occurs,
SmartSafe™ technology
moves the throttle channel to its
designated failsafe position (low
throttle) that was set during binding.
All other channels hold their last
position. When the receiver detects
signal from the transmitter, normal
operation resumes.
Standard Mode
1 Push and Hold Bind Button
2 Power on Reciever
3 Release Button after RX goes into Bind Mode (flashing LED)
4 Place transmitter in Bind Mode and finish Binding
Gas Mode
1 Push and Hold Bind Button
2 Power on Reciever, keep Bind button depressed until
binding is complete
3 Place transmitter in Bind Mode and finish Binding
When the LED turns solid, power off the reicever, and then
4
release the Bind Button
4
Battery
Electronic
Speed Control
Receiver
Bind Button
Gas Mode
Preset failsafe is ideal for most
nitro/gas vehicles. With preset
failsafe, all channels go to their
preset failsafe positions if the
signal is lost, preventing an
out of control situation. When
the receiver detects signal
from the transmitter, normal
operation resumes.

TYPICAL NITRO VEHICLE INSTALLATION

Steering Servo
Throttle Servo
Battery

RECEIVER COMPATIBILITY

The SR315 receiver is compatible with
Spektrum DSM2 and DSMR
®
control surface systems. Install the
receiver in the position recommended by
the vehicle's manufacturer. Double-sided
tape or foam may be used to secure the
receiver in place.

RECEIVER ANTENNA

The SR315 receiver features a coaxial antenna design for easy
installation in almost any model. Think of the last 1 inch (32mm)
on the tip of the antenna as the active portion of the antenna,
the coaxial portion leading up to it is just an extension. Install the
antenna so the active portion is positioned as high as possible in
the vehicle, and not "in the shadow" of any carbon fiber or metal.
Active portion
of antenna
Antenna Tube Not
Included. Tube size
may vary, test for
proper fit.
The case of the receiver can accept an antenna tube directly, making
optimal antenna placement easy (antenna tube not included).
SPEKTRUM DX6C • TRANSMITTER INSTRUCTION MANUAL
Receiver
radio
®
BATT
STR THR AUX1
WARNING: Do not kink,
cut or damage the
antenna wire. The antenna is
made of a coaxial wire; if the
outer sheath becomes
damaged, the receiver will not
work properly. If the antenna is
damaged in any way, replace
the antenna before attempting
to use the receiver.