4.3.
UPDATING THE FIRMWARE IN THE ROUTER
The firmware in the 9512 series routers is contained on a FLASH EPROM built into the microcontroller
chip (MCU), and can be upgraded easily using a computer running Windows 95 or later, and the
appropriate cable connected to the COM1 port on the router rear panel. The firmware file and a special
application called WINISP (which should have been supplied along with the firmware) are required in order
to upgrade the firmware.
4.3.1. Connecting the Computer to the Router
In order to connect the computer you will need a "straight through" cable wired according to Table 4-2
below.
Frame Gnd
Table 4-2: Cable to Connect PC to Router for Updating Firmware
4.3.2. Initiating Programming Mode
There are two methods of initiating FLASH programming which should cover programming for most units.
If neither of these methods is successful, contact the factory for further instructions.
4.3.2.1. Setup Menu Method
This is the recommended method of updating the software in the 9512 series router products. It is
activated through the Setup menu system. Use the SETUP key to enter the menu system, scroll to the
UPDATE SOFTWARE menu using the ↑ or ↓ keys and then press SELECT. The front panel should then
read ERASE ALERT. This warning lets the user know that taking the next step will place the unit in
programming mode and could erase the software already present in the FLASH device. To proceed,
press and hold the SELECT and then press the VIDEO BUS 12 key. This places the unit in programming
mode and opens its serial port to communicate with the WINISP program. The front panel display shows
Programming... Proceed to section 4.3.3 for information about uploading the firmware using WINISP.
4.3.2.2. DIP Switch Method
TECHNICAL DESCRIPTION
Router End
9 pin D
Pin
Male
1
TxD
2
RxD
3
4
Sig Gnd
5
6
RTS
7
CTS
8
9
Shield
X-9512 and X-HD9512 Series Router Manual
9 pin D
Female
-------------
RxD
-------------
TxD
-------------
Sig Gnd
-------------
CTS
-------------
RTS
---drain-----
Frame Gnd
Revision 1.3
PC End
Pin
1
2
3
4
6
7
8
9
Shield
Page 4-3