Table of Contents
Advertisement
Option
Description
Dell Controlled
Controls the turbo engagement. Enable this option only when System Profile is set to Disabled.
Turbo
Dell AVX Scaling
Enables you to configure the Dell AVX scaling technology. This option is set to 0 by default.
Technology
Number of Cores
Controls the number of enabled cores in each processor. This option is set to All by default.
per Processor
Processor Core
Specifies the maximum core frequency of the processor.
Speed
Process Bus Speed Displays the bus speed of the processor.
Processor n
The following settings are displayed for each processor installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Maximum Memory
Capacity
Microcode
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1
Power on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3
On the System Setup Main Menu screen, click System BIOS.
4
On the System BIOS screen, click SATA Settings.
NOTE:
Depending on the number of installed processors, there might be up to two processor listings.
NOTE:
Depending on the number of processors, there might be up to two processors listed.
Description
Specifies the family, model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the maximum memory capacity per processor.
Specifies the microcode.
Pre-operating system management applications
53
Advertisement
Table of Contents
