Table of Contents
Advertisement
4.4.
4.4.1.
4.4.2.
4.4.3.
4.4.4,
4.5.
4.5.1,
49
Genera! directives
—
Before soldering, wires:
should be bent through the holes of solder tags, or wrapped round the tag in the
form of an open
U, or, wiring ridigity shall be maintained by cable clamps or cable lacing.
Safety components
Checking the insulation resistance
Note:
2 MQ
is a minimum requirement at 40 °¢ and 95 % relative humidity.
Under normal conditions the
insulation resistance should be much higher (10 to 20 MQ).
SPARE PARTS
General
Standard Parts
NOTE:
Special Parts
In addition to the standard electronic components, some special components are used:
ATTENTION:
Both type of components
may only be replaced by components obtained through your loca! Philips
organisation.
Advertisement
Table of Contents
