Panasonic EY6406 Instruction Manual page 4

FOR BAHERY CHARG¬
ER ftBAHERY PACK
' > SAVE THESE IN¬
STRUCTIONS .™s
manual contains important safety and
operating instructions for battery
charger EY0230.
2) Before using battery charger, read all
instmctions and cautionary markings
on (1) battery charger, (2) battery
pack.
3)
CAUTION
-To reduce the risk
of injury, charge only Battery Pack
shown below.
EY9CK)1, EY9080, EY9065, EY9006.
EY9086. EY9101. EY9180, EY9182.
EY9106, EY9107. EY9136. EY9230.
EY9200, EY9108
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or
snow.
5) To reduce risk of damaging the elec¬
tric plug and cord, pull by ^ug rather
than cord when disconnecting charg¬
er.
6) Make sure cord is located so that it
will not be stepped on, tripped over,
or otherwise subjected to damage or
stress.
7) An extension cord should not be
used unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be
used, make sure:
a. that pins on plug of extension cord
are the same number, size and
shape as those of plug on charger.
b. that extension cord is properly
wired and in good electrical condi¬
tion.
c. that wire size is large enough for
ampere rating of charger as speci¬
fied below.
RECOMMENDED MINIMUM AWG SIZE Of
EXTENSION CORDS FOR
BATTERY CHARGERS
AC fnput Rating. Amperes AWG Size of Cord
Equal to or But less
greater than than
Length of Cord, Feet
25 50 10O 150
0 2 18 18 18 16
8) Do not operate charger with dam¬
aged cord or plug—replace them
immediately.
9) Do not operate charger if it has
received a sharp blow, been
dropped, or otherwise damaged in
any way; take it to a qualified service¬
man.
10) Do not disassemble charger; take it
to a qualified serviceman when ser¬
vice or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or
cleaning.
12) The charger and battery pack are
specifically designed to work togeth¬
er. Do not attempt to charge any
other cordless tool or battery pack
with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery
pack in locations where the tempera¬
ture may reach or exceed 122°F
(50"C) (such a metal tool shed, or a
car in the summer), which can lead to
deteriorabon of the storage battery.
16) Do not charge battery pack when the
temperature is BELOW 32"F (0"C) or
ABOVE
lOA^F
(40*0). This
iS
very
important.
17) Do not incinerate the battery pack. It
can explode in a fire.
-
4
-