Table of Contents
Advertisement
Connecting an HDMI™ or DVI
device to the HDMI input
The HDMI input on your television receives digital
audio and uncompressed digital video from an
HDMI source device, or uncompressed digital video
from a DVI (Digital Visual Interface) source device.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) programme material in digital
form from EIA/CEA-861-D–compliant
devices (such as a set-top box or DVD player with HDMI or DVI
output). For acceptable video signal formats, see page 38.
NOTE: Supported Audio format: Linear PCM, sampling rate
32/44.1/48kHz.
To connect an HDMI device
Connect an HDMI cable (type A connector) to the HDMI
terminal.
For proper operation, it is recommended that you use an HDMI
cable with the HDMI Logo (
• If your HDMI connection is capable of 1080p and/or your
television is capable of refresh rates greater than 50Hz, you
will need a Category 2 cable. Conventional HDMI/DVI cable
may not work properly with this mode.
• HDMI cable transfers both video and audio. Separate
analogue audio cables are not required (see illustration).
• See "HDMI1 Audio" on page 31.
The HDMI 3 terminal is located on the side of the television.
HDMI cable
HDMI device
VIDEO
AUDIO
L
R
IN
OUT
R
L
To view the HDMI device video, press the
HDMI1, HDMI2 or HDMI3 mode.
[1]
consumer electronic
).
HDMI OUT
o
button to select
9
To connect a DVI device
Connect an HDMI-to-DVI adapter cable (HDMI type A
connector) to the HDMI 1 terminal and audio cables to the PC/
HDMI1 (AUDIO) socket (see illustration).
• The recommended HDMI-to-DVI adapter cable length is 2m
(6.6 ft).
• An HDMI-to-DVI adapter cable transfers video only.
Separate analogue audio cables are required.
• See "HDMI1 Audio" on page 31.
Audio cable for HDMI to
television connection
(not supplied)
DVI device
VIDEO
AUDIO
L
R
IN
OUT
L
R
NOTE:
To ensure that the HDMI or DVI device is reset properly, it is
recommended that you follow these procedures:
• When turning on your electronic components, turn on the
television first, and then the HDMI or DVI device.
• When turning off your electronic components, turn off the
HDMI or DVI device first, and then the television.
[1] EIA/CEA-861-D compliance covers the transmission of uncompressed
digital video with high-bandwidth digital content protection, which is
being standardized for reception of high-definition video signals. Because
this is an evolving technology, it is possible that some devices may not
operate properly with the television.
HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
CONNECTING YOUR TV
HDMI-to- DVI
adapter Cable
DVI /HDCP
OUT
Advertisement
Table of Contents
