Philips 5000 Series User Manual page 11

8
Use a screwdriver to con�rm that the
deadbolt locks and unlocks smoothly.
Install the Exterior Assembly
Attention
Before installing the Exterior and Interior Assembly,
make sure the Latch Bolt is fully retracted (in the
unlocked position).
Unlocked
Do not insert the key when you are installing.
Measure the diameter of
the hole in the door.
1-1/2" or 2-1/8"
(38 or 54mm)
Locked
1-1/2" (38mm)
Remove the spacer
2-1/8" (54mm)
Proceed to next step
9
Install the Strike Plate on the door frame.
Attention
Make sure the hole in door frame is drilled a minimum
of 1"(25mm) deep.
10
With the Latch Bolt fully retracted (in the
unlocked position), route the cable below
the Latch Bolt, and insert the tailpiece
through the slot in the Latch Bolt.
Attention
The Upper Screw & Screw Post on the top is OPTIONAL.
It is used for additional security, or when a door is weak
or warped.
11
Move the Installation Buckles on both sides of
the Interior Assembly upwards to remove the
Mounting Plate from the interior base.
Strike Plate Screws
(Optional)
Tailpiece
9