Maintenance; Warranty - SUNTEC SP500C Pro Operating Manual

Error Messages
Msg. Description
ER01 Coil temperature sensor error
ER02 Ambient temperature sensor error
ER03 Humidity sensor error
ER04 Ambient temperature is over the operation range, which is 1 – 40
ER05 High Pressure Switch off
ER06 Low Pressure Switch off
ER07 Communication error.

Maintenance

When it is not going to be used for a long time
Set 80% RH as desired humidity for 3 or 4 hours to dry the inside of the
l
dehumidifier.
l Turn off the dehumidifier and then disconnect the power plug.
l Remove battery from Remote Control.
When the dehumidifier is going to be used again
l Make sure the air inlet and air outlet does not be blocked.
l Check the ground wire is connected correctly.
WARNING! Always unplug any dehumidifier before performing maintenance
procedures.

Warranty

SunTec warrants to the original purchaser that if, within a period of 12 months from
the date of purchase, this equipment is found to be defective either in original
materials or workmanship (excluding normal usage wear and/or mishandling or
abuse) the faulty part will be replaced free of charge upon presentation of the
appropriate evidence, provided the unit is returned to the original supplier. Shipping
expenses are not covered under the warranty.
How to install the dehumidifier on the wall?
o
C.
How to change the filter on the dehumidifier?
Step 1: Choose the right installation position for
the wall support according to the size of installing
holes and the wall bracket holes position. The
installation position should guarantee
dehumidifier in horizontal position. The position of
the exploded screw should be marked.
Step 2: Use the M8 percussive drilling machine to
drill holes of 8mm +-0.5mm depth. Then take the
nuts and gaskets off from the exploded screw and
fix them into the holes with the hammer.
Step 3: Install the wall bracket with the exploded
screw on the right position. Please take care to fix
the bracket well with the nuts and gaskets. And
don't forget to keep the bracket in the right
direction during the installation.
Step4: Hang the dehumidifier on the wall bracket
and aim dehumidifier base installing holes at the
bracket holes. Fix the dehumidifier on the bracket
with the fix screws and gaskets.
Step5: Plug in the Condensation Pipe Connector
to the bottom central hole of the machine, then
connect a suitable piping.
Step 1: Use screwdriver undo two screws at the
bottom of the machine.
Step 2: Remove the metal cover filter plate and
let the HAF filter drop off.
Step 3: Change a new filter.
the