Table of Contents
Advertisement
CHARACTERISTICS
INSERT Range Hood is designed for designer's kitchen with the range
hood hidden inside the cabinet, special molding design and metal or
copper hood. No more visual machine hanging under the cabinet.
Provide you a continue face of cabinets in your kitchen but at the same
time have the range hood hidden and provide you with the benefit of
extracting the oil and smoke from your cooking.
Installation is simple. Please refer to the instruction below.
INSTALLATION & USE
NOTE: remove protective film (if any) from the exterior surfaces of the
hood carefully prior to final installation.
DESCRIPTION / CONNECTION
This appliance should be mounted to the bottom of a standard wall
cabinet. Duct work can be installed vertically or horizontally.
1. Duct runs should be as short as possible.
2. Avoid the use of elbows.
3. Use duct tape at all joints.
4. Do not use duct smaller than the discharge on the hood.
LOCATION PREPARATION
The installation in this manual is intended for qualified installers,
service technicians or persons with similar qualified background.
DO NOT attempt to install this appliance yourself. Injury could result
from installing the unit due to lack of appropriate electrical and
technical background.
All electrical wiring must be properly installed, insulated and grounded.
Overly accumulated grease in old duct work should be cleaned out or
duct work should be replaced if necessary to avoid the possibility of a
grease fire. Check all joints on duct work to insure proper connection
and all joints should be properly taped.
3
Advertisement
Table of Contents
