Deleting The Specification Limits / Offset Value - FISCHER PERMASCOPE MP0R Operator's Manual

Table of Contents

10. Press button [OK] to accept this value into the memory. The menu

TOL

will be left.

Now the specification limits are set. The instrument is ready to make

measurements. The new captured measurements will be monitored if they

are between or outside the specification limits. Additional the offset value

will subtracted from the captured reading if an offset value is set.

7.2

Deleting the specification limits / Offset value

Before you start

Instrument must be turned ON by pressing the key [OK].

Procedure

• Procedure as described on page 21.

• Instead of getting the approximate values set the desired value (MIN,

MAX, OFFS) or all values to 00.0.

Now the specification limits no longer apply. The MIN and MAX values are

deleted from the memory. The instrument is ready to make measurements.

Operator's Manual for instrument types MP0R

Table of Contents

Do you have a question about the PERMASCOPE MP0R and is the answer not in the manual?