Basic Operation, Audio And Clock Adjustment - Sony CDC-X30MP Operating Instructions Manual

BASIC OPERATION,
AUDIO AND CLOCK
ADJUSTMENT
Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/rear), H-BASS (high bass)*, DSSA (Drivers
Sound Stage Adjustment)** and BBE***.
• You can reinforce the bass sound.
** You can adjust sound stage and tone balance to best
serve a particular seat in the car.
*** You can enhance theclarity of high-frequency sound.
1 Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode appears on the display.
2 Turn Jog dial to increase or decrease the level for
the selected mode (except for H-BASS, DSSA and
BBE).
In H-BASS mode, turn Jog dial to select 1,2, 3 or
OFF.
In DSSA mode, turn Jog dial to select L (forthefront
left seat), R (for the front right seat) or OFF.
In BBE mode, turn Jog dial to select f, 2 or OFF.
Notes
• Adjust the level or select an item within 5 seconds, or
the selected mode will return to previous state.
• When DSSA is activated, you cannot adjust BAL and
FAD.
Changing the source mode
Aligning the source levels
1 Press Jog dial (PUSH-SOURCE).
Pressing Jog dial (PUSH-SOURCE) cycles through
source modes in the following order:
FI (F2/F3/A1/A2) -> DISC* -> AUX IN
t_I
* "DISC" does not appear on the display when there is
no CD in the unit.
Adjusting the volume
1 Turn Jog dial.
"VOL (volume)" appears on the
V0v
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
1 Press Jog dial (PUSH-SOURCE) or TU (TUNER)
repeatedly to select the desired mode.
2 Press DSPL while pressing SEL.
"LEVEL 0" appears on the display.
3 Turn Jog dial to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Muting the sound
1 Press PWR/ATT briefly.
"ATT ON" appears on the display.
To restore volume, briefly press PWR/ATT again.
Restoring the factory settings
1 Turn off the unit.
2 Press and hold DSPL until "LEVEL appears on
the display.
Note
You can restore thefactory settings only for VOL, BASS,
TRE, BAL, FAD, H-BASS, DSSA and BBE, and aligned
3 ENGLISH