Pioneer F-225L Operating Instructions Manual page 7

OPERATIONS
Listening to FM or AM broadcasts.
<Auto tuning can be used for both FM and AM (MW)
reception. >
(1) Use the AUTO/MANUAL switch to select the auto
tuning mode or the manual tuning mode.
*When the auto tuning mode is selected, the AUTO
TUNING indicator will now light.
{2) Use the BAND selector switch to select either the
FM or AM (MW or LW) reception band.
+ For FM broadcasts, the "FM" and "MHz" indicators will
light.
° For AM broadcasts, the "AM" and "kHz" indicators will
light.
{3) Press the-(Down ) or + (Up) of the TUNING
switches.
Auto tuning [FM, AM (MW)}:
The tuner will automatically search for a broadcasting
station, and stop when one is found. To search for another
station, press again.
Manual tuning [FM, AM (MW, LW)]:
The tuning frequency will change by one step each time the
switch is pressed. Press as many times as necessary to tune
in the desired station.
lf the switch is held depressed, the reception frequency will
change continuously, and stop when the switch is released.
(4) When you wish to receive a different station
within the same band, repeat step (3). To receive
a station on a different reception band, repeat
steps (2) and (3).
(5) Adjust the volume and tone of the stereo amplifier.
NOTE:
When AUTO TUNING is in use, reception may not be possible
when signals are weak. At these times MANUAL TUNING is
recommended.
Memorizing FM and AM stations
You can memorize 12 FM and AM stations in Mode 1, and 12
stations in Mode 2, that is a total of 24 stations.
{1) Use the BAND selector switch to select either the
FM or AM reception band.
« For FM broadcasts, the "FM" and "MHz" indicators will
light.
* For AM broadcasts, the "AM" and "kHz" indicators will
light.
(2) Use the TUNING switches to tune in the desired
station.
When memorizing' an n FM station, either press the FM
MONO switch to forcibly memorize the station in the |
monaural mode, or memorize the station in the auto
stereo mode (with FM MONO switch left in the OFF
sition). position)
(3} Press the MEMORY switch.
¢ The display will flash (about 10 seconds).
EMORY
ru oad
8
<ARB1159>
(4) Press the STATION CALL switch.
+ While the display is flashing, press the switch corresponding
to the station which you: wish to memorize oF re- memorize,
I When memorizing a station to Mode 1 {e.g. memoriz-
ing a station to No. 9):
a
By pressing the station call switch ¢ once, s, the Station will be
memorized to Mode 1 (1-12).
| When memorizing a station to Mode 2 (e.g. memoriz-
ing a station to No 21):
By pressing the station call switch t
memorized to Mode 2 (13-24),
« After you press the STATION CALL switch, the display will
flash for about 2 seconds, then the station will be
memorized. If you press another switch while the display
is flashing, the station will not be memorized.