Headphone Jack - Pioneer CT-1040W Service Manual

'CT-1040 Ww
@ RECORDING LEVEL CONTROL
This control is used to adjust the input from the rear panel REC ter-
minals and the MIC jack. When rotated clockwise ( (} ), the recor-
ding level is increased; when rotated counterclockwise ()), the
level is reduced. The standard input level is obtained when the con-
trol is set to the center clickstop position (¥).
@® *DOLBY NR SWITCH
Press this switch to the ON ( m=. ) position when recording material
with the Dolby noise reduction system or when playing back a tape
which has been recorded with the system. Release the switch to the
OFF ( Hl ) position when recording material without the Dolby
system or when playing back a tape which has not been recorded
with the system.
voi
oT
*The word "Dolby" and DO] are trademarks of Dolby Laboratories
Licensing Corporation.
Noise Reduction System manufactured under license from Dolby
Laboratories Licensing Corporation.
@ PHONES SWITCH
While a tape is playing back in Deck B, the programs played back on
Deck A can be heard through headphones. This function is used
when preparing the next program for your friends to sing along
with, for instance. Refer to the table for the rear panel PLAY ter-
minal output with Deck A and Deck B playback and for the head-
phone jack output when the phones switch is selected.
GHA
MS &
PLAY BACK
8
SYNCED BEC START
beecon
(@eay) PHONES PHONES
DECK A | DECK B TERMINAL SWITCH JACK
_|__ OUTPUT POSITION OUTPUT
Playback | Playback | Deck B output A or B ( Ml ) | Deck B output
Playback | Playback | Deck B output
Playback | _
A ( mm) | Deck A output
A or B{ BB) | Deck A output Deck A output
Playback — Deck A output A ( m) -
_ Playback | Deck B output A or B( BB) | Deck B output
Playback
@ MIC JACKS
These are the input jacks for microphone recording. Plug the left
channel microphone into the L jack and the right channel
microphone into the R jack.
@ HEADPHONE JACK
This is the output jack for the stereo headphones. Plug the head-
phones into this jack to monitor the quality of a recording or to listen
to a tape privately.
NOTE:
Use headphones with a low impedance. Sufficient volume will not
be obtained with high-impedance headphones.
@® COPY INDICATOR
This lights when the COPY switch is pressed.
@ HIGH SPEED INDICATOR
This fights when the HIGH SPEED switch and COPY switch are
pressed.
@ RELAY PLAY INDICATOR
This lights when the RELAY PLAY switch is pressed.
Deck B output
3. DISASSEMBLY
Front panei assembiy
Operation switch B
assembly
Fig. 3-1 Disassembly
Control assembly
<A
Ke Eo
Sensor R/P S ge <9
assembly
Sensor P assembly
Operation switch A assernbly