Sanyo VHR-757G Service Manual page 7

9
9
1-2. TEMPORARILY SETTING UP AND CONNECTING CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1. Place the mechanism unit and main board up side down as 2. Operete the unit using the buttons on TM-1 PWB or the
a whole on a flat surface with foil side of the main board remote control.
facing up.
M-PF2LN/TA-4
CP-1 PWB Assembly (Foil side)
Terminal Boord
TM-1 PWB
Cassette Compartment
Mechanism Main Unit
1-3. INSTALLATION OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1. Pressing down the door opener lever of the mechanism Note: Opened cassette door position does not install the front
main unit. panel to the chassis.
2. Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
Front Panel
Cassette Door
(Position A)
Cassette Door
(Position B)
Fig. 1-1-5