Voltage Selector - Yamaha PX-2 Owner's Manual

PX
Ren
L] Location of instaliation.
Avoid placing the PX-2 where its total quality will
be illaffected, or malfunctions result, from excessive
heat (in direct sunlight or near heating equipment),
cold, humidity or dust,
[I Use of benzene or thinners is to be strictly
avoided.
Do not wipe the cabinet with chemical solvents
(such as benzene or thinner),. or spray aerosol-type
insecticides near the machine. Adhesion of benzene,
or thinner will cause stains or discolor the cabinet.
Be sure not to let record spray reach the cabinet
when cleaning discs. Clean only with a soft, dry
cloth.
LI Handle with care.
Careless handling — knocking against it, dropping
something on it — may damage the product and
deteriorate performance. Be sure to handle it with
care.
O Select a place free of vibrations.
Do not place the PX-2 in locations subject to high
vibrations, or close to a speaker system. Select a
firm base to place it upon.
C] Avoid using an old, worn down stylus.
The service life of a stylus differs according on the
condition of discs but, in normal use, a diamond-
tip stylus should be replaced after 200 ~ 300 hours
of use. Using a worn-down stylus may cause distor-
tion, ''scratchness'' and damage to discs.
L! Handle the power cord with care; grasp the plug
when removing the cord from the AC outlet socket.
LI Place at a sufficient distance from amplifiers.
When installing in parallel with the audio amplifier
to which it is to be connected, place the PX-2 so
that the tonearm will be as far away as possible
from the power transformer side of the amplifier.
Also be sure to keep the output cord separated ata
distance from the power supply.
L] Keep it level,
Speed of revolution and tonearm movement will be
adversely affected if the turntable is not properly
leveled.
[1 Moving and transportation.
When it is necessary to move the unit — for example,
to change the layout of the listening room — be sure
to keep the unit level. If tilted, there is danger of
the arm unit slipping out. When transporting it
when moving to another house, pack it firmly to
protect the arm unit, (Refer to Page 4.)
LI If a foreign object falls inside.
The section the tonearm moves over is of an open
construction for mechanical reasons: special
attention should be paid not to drop any foreign
object inside, If something should fall inside, turn
off the power switch immediately and remove the
object. If it has fallen into an inaccessible place, do
not attempt to open the cabinet; instead, contact
your local YAMAHA dealer or service representative.
O Keep this Owner's Manual in a safe place for
future reference.
LI The voltage selector switch on the cabinet of the
PX-2 must be set for your local mains voltage
BEFORE plugging in the AC main supply. Voltages
are 110/120/130/220/230/240 V AC, 50/60 Hz.
(General Model Only)
VOLTAGE SELECTOR
(General Model Only)
U.S.A., Canadian and British Models
The following "CAUTION" label is attached
to the cabinet.
" CAUTION-TO PREVENT ELECTRIC SHOCK, DO.
"NOT REMOVE COVER OR SCREWS. NO USER-
SERVICEABLE PARTS INSIDE, PILOT LAMPS
SOLDERED IN PLACE. REFER. SERVICING TO
QUALIFIED. SERVICE PERSONNEL. ` isois