Page 4
• Identifiers for connections, nated. Local directives or general directives [e.g. • Name plate, IEC, VDE etc.] and local power supply companies • Warningsticker must be adhered to. must be strictly complied with and kept in legible condition. WILO SE 04/2023...
5.1 Place of installation The domestic water system must be installed in a shelter or in a room which is easily accessible, normally ventilated, and protected from frost. Installation and operating instructions - Wilo-Initial JET system...
CAUTION! Fill the pump before restarting it. Power supply network Do not let the pump run more than a few minutes Single-phase 230 V: connect using the cord with a closed discharge valve. (H07RN-F or equivalent) with normalised plug (Fig. 1, pos. 6). WILO SE 04/2023...
The voltage is too low Check the current using an ammeter or set to the current indicated at the motor rating plate One phase is interrupted Verify the connections of the power cord Installation and operating instructions - Wilo-Initial JET system...
Page 8
English 9. Spare parts All spare parts must be ordered through the Wilo customer service. Please state all data shown on the rating plate with each order to avoid queries and incorrect orders. 10. Disposal Information on the collection of used electrical...
Page 16
Local contact at www.wilo.com/contact WILO SE Wilopark 1 D-44263 Dortmund Germany T +49(0)231 4102-0 F +49(0)231 4102-7363 wilo@wilo.com Pioneering for You www.wilo.com...
Need help?
Do you have a question about the Initial JET System and is the answer not in the manual?
Questions and answers