Advertisement
C) Ice-cubes thickness thermostat
D) Water inlet connection
Fig. 10:
A) On/off switch (green)
B) Wash switch (blue)
OPERATION
STARTING UP
-— Press the green switch.
ADJUSTING THE ICE CUBE THICKNESS
ADJUSTING THE ICE CUBES LEVEL
The thermostat is pre-set at the factory.
MAINTENANCE
During freezing, the calcium in the water is deposited on the
refrigerated plate. These deposits act as insulation, decreas-
ing the efficiency of the appliance's performance.
To clean the water system, proceed as follows:
2) Open the ice bin and remove all the cubes.
3) Remove the plug inside the bin (Fig. 8) to drain the water
from the bin.
SERVICE
— There is power at the outlet.
— the plug is connected correctly to the socket
— one of the power cord wires is not disconnected.
The wash switch is pressed.
.
;
— the thermostat is set according to the instructions given.
If the ice cubes are too thick or too thin, check that:
— the thermostat knobs are positioned according to instruc-
tions.
If ice cubes formation takes too long.
If there is no water in the ice bin, check that:
— the drain hose is well connected
— the drain hose is not clogged or kinked.
If the ice cubes are not transparent, check that:
If after the above checks, the unit is still not working properly,
contact your dealer or Service. Describe the nature of the
fault and give the mode! of the unit. The model number is
printed on the rating plate at the back of the appliance (Fig. 2).
5
Advertisement
