Related Manuals for Clarke DEVIL 7003
Summary of Contents for Clarke DEVIL 7003
- Page 1 Only suitable for well insulated areas and not designed to be the primary heat source 3KW ELECTRIC FAN HEATER MODEL NO: DEVIL 7003 PART NO: 6935450 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS DL0623 - ISS 9...
-
Page 2: Environmental Recycling Policy
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase. - Page 3 THE FOLLOWING TABLE ADDRESSES THE INFORMATION REQUIREMENTS OF REG.2015/1188 Item Symbol Value Unit Heat output Measured seasonal space heating energy efficiency Nominal heat output Minimum heat output (indicative) Maximum continuous heat output Auxiliary electricity consumption At nominal heat output At minimum heat output In standby mode Type of heat input for electric storage local heaters only Manual heat charge control with integrated thermostat...
-
Page 4: Safety Symbols
SAFETY SYMBOLS The following symbols appear on the unitt. Hot Surface, Do Not Cover Do Not Touch SAFETY RULES Make sure that you read, understand and comply with the following. ELECTRICAL SAFETY WARNING: THIS HEATER MUST BE EARTHED • Regularly inspect the power cable / plugs and all electrical connections for signs of damage/looseness. -
Page 5: Maintenance
Cleaning and Maintenance. • Use recommended parts only. Unapproved parts may be dangerous and will invalidate the warranty. • DO NOT attempt to repair a damaged heater, contact the Clarke service department. POSITIONING WARNING: DO NOT USE THE HEATER NEAR FLAMMABLE MATERIAL, LIQUIDS, SOLIDS, GASSES OR COMPRESSED GAS CYLINDERS ETC. -
Page 6: Common Sense
COMMON SENSE • DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication. • DO NOT stand on the heater. • DO NOT use the heater with wet hands or when there is water on the power cable. -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below. -
Page 8: Operation
OPERATION WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS WHEN THEY ARE OCCUPIED BY PERSONS NOT CAPABLE OF LEAVING THE ROOM ON THEIR OWN, UNLESS CONSTANT SUPERVISION IS PROVIDED. CAUTION: SOME PARTS OF THIS PRODUCT CAN BECOME VERY HOT AND CAUSE BURNS. -
Page 9: Adjusting The Angle
3. Retighten the handwheels. SAFETY SYSTEMS THERMOSTATIC PROTECTION The Devil 7003 has a manual reset thermal cut out to prevent the unit from overheating. If the thermal cut out activates, then turn off the power and disconnect from the power supply. Allow the heater to cool down for several minutes before pressing the reset button. -
Page 10: Specifications
• Make sure that the heater grill is not blocked. • No other maintenance is required, should you discover any problem with the heater, return it to the Clarke service department for repair. SPECIFICATIONS Operating Voltage and Frequency: (V/Hz) 230 V / 50Hz Operating Temperature: (Min/Max) (°C):... -
Page 11: Troubleshooting
Fuse blown or Replace if necessary and investigate although circuit breaker cause. If fuse blows plugged in trips. repeatedly, consult your Clarke dealer. with the No power at Insert the plug in a funtioning socket switch and socket outlet thermostat switched on. -
Page 12: Parts Diagram
PARTS DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 13: Parts List
PARTS LIST Front Grille Fix Part For Tilt Switch Heating Elements Supply Cable Entry Chassis Panel Power Cable Thermal Cut Out Retaining Clips Bush Adjustable Knob Motor House Casing Rear Grille Speed Controller Securing Plate Location Part For Switch Spacer Temperature Controller Plastic Handle Upper Securing Rings... - Page 14 DECLARATION OF CONFORMITY - UKCA Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 15: Declaration Of Conformity (Ce)
DECLARATION OF CONFORMITY - CE Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the DEVIL 7003 and is the answer not in the manual?
Questions and answers