Table of Contents
Advertisement
11. Replace Grease(6 ounces of 930-2
Benalene) on the gears. Build up in a
cone shape.(Fig. 31)
Fig. 31 Grease
12. Check the gasket and make sure it is not
ripped or missing(Fig. 32)*(Serial
number WL09 – WL16 does not use a
gasket) and Set Transmission Housing
into place.(Fig. 33) It is highly
suggested to change the plastic
transmission cover out with a new
Magnesium housing and
gasket.(8212396) If the housing does
not sit all the way down use your finger
to turn the attachment hub gear.(Fig. 34)
Fig. 32 Inspect Gasket
Fig. 33 Transmission Cover
Fig. 34 Turn hub gear
13. Use your thumb to push the motor
forward and tighten the 2 motor screws.
1 on each side of the motor.(Fig. 35)
Fig. 35 Tighten Motor
14. Attach green ground wire with 1 screw.
Advertisement
Table of Contents
