Changing door stop
WARNING!
Before changing the door stop, disconnect the mains plug.
1.
Open loading door.
Unscrew hinge A from the front of
2.
the machine and take off the load-
ing door.
3.
Remove cover plates B. To do this,
insert a thin screwdriver into the
slots as shown in the illustration,
press downwards slightly and pry
out the cover plates.
4.
Use an appropriate tool and exert
pressure to unfasten locking block
C from the snap-on fixture, take out
and re-insert on the other side hav-
ing rotated the block through 180°.
Unscrew hinge A from the loading
5.
door, rotate through 180°, re-insert
on the opposite side and screw
down.
Re-insert cover plates Bon the op-
6.
posite site having first rotated them
through 180°.
Installation
A
A
39
B
C
B