Page 11
Wireless Amplifier E500W Preface Dear Customer, Thank you for purchasing Takstar E500W Wireless Amplifier. In order to better understand and use the product, please read this manual carefully. If you have any questions or suggestions, please contact our local dealer. Features Wireless amplifier with dual voice coil speaker, powerful magnet, 20W high •...
Page 13
• Charging Time: about 2 hours (0db=1V/Pa/m at 1kHz) • Playtime: about 4 hours • Battery Type: lithium-ion battery • Net Weight: about 39g Note :The above data are measured by Takstar laboratory which has the final interpretation right! Function Descriptions Voice Amplifier ⑫...
Page 14
Wireless Amplifier E500W ① Power switch: rotate the dial to MAX until you hear a click to power on the device and then gradually increase the volume level. Once powered on, the LED display shows “UHF”, meaning the device is ready for voice amplification.
Page 15
Wireless Amplifier E500W ④ Play/Pause button: press it to play or pause the music. When playing in Bluetooth, long press this button to disconnect Bluetooth, followed by a voice prompt “Bluetooth disconnected”; long press this button again to reconnect Bluetooth, followed by a voice prompt "Bluetooth connected". When playing...
Page 16
Wireless Amplifier E500W Handheld Microphone Power button: long press it to turn on/off the mic. ① When powered on, press it twice to start pairing, or press it once to change frequency. When powered off, long press it for 10 seconds to switch between A/B channel.
Page 17
Wireless Amplifier E500W Power switch: toggle switch to ON or OFF to power on or off respectively. ① Display: display working channel, mic volume and power status. ② ③ M button: used for changing frequency, refer to “Pairing Method” section for details.
Page 18
Wireless Amplifier E500W Operation Instructions A. Pairing Method The products are paired by factory default and will automatically connect to each other once powered on. No extra pairing is required. If there is signal interference, follow the below steps to re-pair or change frequency: Handheld Microphone: 1.
Page 19
Bluetooth discovery and pairing, indicated by a blinking “BLUE” symbol. ② Enter SETTINGS menu on your phone, find and enable Bluetooth, wait until “TAKSTAR E500W” is discovered and tap on it to connect. When connected successfully, there will be a voice prompt about “Bluetooth Connected”.
Wireless Amplifier E500W Safety Instructions To avoid electric shock, overheat, fire, radiation, explosion, mechanical risk and injury or property loss due to improper use, please read and observe the following items before use: 1. Please check if the power of the connected equipment matches with that of this product before operation.
Page 21
Wireless Amplifier E500W Label Meanings This symbol indicates that this product should not be disposed of with your household waste, according to the WEEE directive (2012/19/EU) and your national law. This product should be handed over to an authorized collection site for recycling waste electrical and electronic equipment (WEEE).
Page 22
This manual contains up-to-date technical specifications as of printing. However, specifications contained herein may not conform to your particular product since Takstar is constantly improving its products. Also, specifications, devices or accessories available may vary from region to region. If you have any questions, please contact our local sales outlet.
Need help?
Do you have a question about the E500W and is the answer not in the manual?
Questions and answers