Projector Parts and Functions
Projector Parts - Base
Name
Function
Front feet
When the projector is set up on a surface such as a
A
desk, turn to extend the foot to adjust the position of
the image.
You can adjust the position of the image by tilting the
projector up to 10 degrees. The larger the angle of tilt,
the harder it becomes to focus.
Screw hole (for the
Screw hole for securing the ring of the safety wire to
B
ring of the safety
prevent the projector from falling from the ceiling or
wire)
wall.
Name
Function
Rear feet
When the projector is set up on a surface such as a
C
desk, turn to extend and retract the feet to adjust the
horizontal tilt.
You can adjust the tilt within a range of ±1.5°. The rear
feet are detachable. You can extend the feet by
approximately 12 mm before they detach.
Security cable
Pass the theft-prevention wire lock through here and
D
attachment point
lock it in place.
Screw holes (for the
The screw holes for securing the cable cover.
E
cable cover)
Make sure the cables have been passed through the
notch on the base of the cable cover before attaching
the cable cover.
Air filter cover screws Screws to fix the air filter cover in place.
F
Cable holder
Pass the cable of the optional external camera through
G
here to secure the cable.
External camera
Use these points to attach the optional external camera.
H
fixing points
Ceiling mount fixing
Use these points to attach the optional ceiling mount
I
points (ELPMB67, 4
when installing the projector on a wall, or mounting
points)
the projector from a ceiling.
g g Related Links
• "Installing the Safety Wire"
p.16
Installing the Safety Wire
When you use the optional ceiling mount, you can install the safety wire to
prevent the projector from falling from the ceiling.
Warning
Do not attach the safety wire to this point.
16