Table of Contents
Advertisement
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (Refer to page 35,)
1,
Set the MULTI-PAGE select switch, on the side of the remote control, to VCR.
2.
Turn ONVCR.
3.
Aim the remote control at the front of the VCR.
4.
Press and hold down the PROG button.
5.
While holding down the button, enter the 2 digit preset code which matches the VCR as shown on page 35. The remote will turn
OFF the VCR when the correct code is entered, indicating that the remote is now programmed.
I NOTES:
If the VCR does not turn OFF after 5 seconds, the wrong code was entered.
Consult page 35 again and try one I
of the other codes listed for that VCR brand name.
I
NOTES:
1.
If your VCR cannot be operated after performing the
above procedures, your VCR's
code has not been
precoded into the remote.
2.
In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control
After replacing the batteries repeat the
entire programming procedure as stated above.
4.
If your VCR does not have a power function, the remote
will issue the CHANNEL UP function.
5.
The MENU button will act as the VCR MENU button for
HITACHI VCRs.
6.
The LST-CH button will act as your VCR ENTER button if
required,
7.
The SLEEP button will act as your VCR '100' button if
required.
8.
The REC button must be pressed two times to begin VCR
recording.
This button will also act as the VCR record
button when the remote is in CABLE or SAT mode.
(_
PRECODED VCR buttons
These buttons transmit the chosen precoded VCR codes,
(_
EXCLUSIVE TV buttons
These buttons are for operating the "IV.
32
Advertisement
Table of Contents
