Setting Up The Base Unit (Wall Mounting) - Toshiba FT-8901A Owner's Manual

SETTING UP THE BASE UNIT (WALL MOUNTING)

MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket's tabs into the
notches on the base.
Flip the switch hook tab
over so the tab holds the
handset.
• Route the cords through the guides.
• Place the base unit on the posts of the wall plate and push down until it is
firmly seated.
• USE ONLY WITH Supplied AC ADAPTOR (TAC-8930 power source AC
120V, 60 Hz/DC 9V).
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don't have a standard wall plate, cut out the template on this page and
use it to position two screws (minimum length of 1
with the heads protruding about
CUT
•
•
Raise the antenna.
1 /
4
Wall mount template
IMPORTANT:
Before mounting, select a wall area of sufficient
strength. If mounting on wallboard or in an area
of questionable strength, locate a stud for
maximum support of your telephone.
Avoid electrical cables, pipes, or other items
behind the mounting location that could cause a
hazard.
INSTALLATION
Telephone
Line Cord
AC Adaptor
/ inches) into the wall
3
8
inch.
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120V, 60Hz)
CUT
11