Ss Ckestseatiet Iid Aabiaaus Iglibsciecss Ceiguceenersqete - Sony CDP-761 Operating Instructions Manual

yVelolhelelermlstielatiecliceys)
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
=>Check that the player is connected securely.
=> Make sure you operate the amplifier correctly.
=> Adjust the playback level using the LINE OUT/
PHONE LEVEL control. (except for CDP-761E)
The CD does not play.
=> There's no CD inside the player ("no dISC"
appears). Insert a CD.
=> Place the CD with the label side up on the disc
tray correctly.
=>Clean the CD (see page 14).
> Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
The recording level has changed. (except for CDP-761E)
=> When you connect the amplifier via the
VARIABLE LINE OUT jacks, the recording level
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording.
The remote does not function.
=> Remove the obstacles in the path of the remote
and the player.
=> Point the remote at the remote sensor & on the
player.
=> Replace all the batteries in the remote with new
ones if they are weak.
= a s
Specifications
Compact disc player
Laser Semiconductor laser
Wavelength 780 - 790 nm
2 Hz to 20 kHz +0.5dB
CDP-761: More than 113 dB
CDP-561: More than 108 dB
CDP-761E/561E : More than 100 dB
CDP-461: More than 102 dB
CDP-761/761E/561/561E :
More than 99 dB
CDP-461: More than 98 dB
CDP-761/761E : Less than 0.0025%.
CDP-561/561E : Less than 0.0027%
CDP-461: Less than 0.0035%
CDP-761: More than 105 dB
CDP-561: More than 103 dB
CDP-761E/561E : More than 95 dB
CDP-461: More than 100 dB
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Outputs
PPS
Jack Maximum Load
type output impedance
level
LINE OUT Phono 2 V Over 10 kilohms
(FIXED)* jacks (at 50 kilohms)
LINE OUT Phono =—-.2V Over 50 kilohms
(VARIABLE)** jacks (at 50 kilohms)
DIGITAL Optical -18 dBm Wave length: 660 nm
OUT output
(OPTICAL) connector
PHONES** Stereo 10 mW 32 ohms
phone
jack
* LINE OUT for CDP-761E
*™ except for CDP-761E
General
Power requirements 220 V — 230 V AC, 50/60 Hz
CDP-761/761E/561/561E: 13 W
CDP-461: 12 W
430 x 110 x 295 mm
Power consumption
Dimensions (approx.)
(wihid) (17 x 4 3/8 x 11 5/8 in.) inel. projecting
parts
Mass (approx.) CDP-761/761E: 4.1 kg (9 Ibs 1 oz)
CDP-561/561E: 3.8 kg (8 Ibs 4 oz)
CDP-461: 3.7 kg (8 Ibs 2 oz)
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.