Table of Contents
Advertisement
Error messages
If an error message with
"
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
The tempera-
"‹‚†
ture in the cook-
ing
compartment is
too high.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers is
found on the side of the oven door. To save time, you can make
a note of the number of your appliance and the telephone
number of the after-sales service in the space below, should it
be required.
E no.
Energy and environment tips
Here you can find tips on how to save energy when baking and
roasting and how to dispose of your appliance properly.
Saving energy
Only preheat the oven if this is specified in the recipe or in
■
the operating instruction tables.
Use dark, black lacquered or enamelled baking tins. They
■
absorb the heat particularly well.
appears, press the
0
button. Then
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
The oven door locks and
heating is suspended. Wait
until the oven has cooled
down. Press the
0
and reset the clock.
FD no.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).
$
button
Refit the glass cover. When doing this, insert it on one side
4.
and press firmly on the other side. The glass cover will click
into place.
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
After-sales service
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0844 8928999
GB
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
01450 2655
IE
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.
Open the oven door as infrequently as possible while you are
■
cooking, baking or roasting.
It is best to bake several cakes one after the other. The oven
■
is still warm. This reduces the baking time for the second
cake. You can also place two loaf tins next to each other.
For longer cooking times, you can switch the oven off
■
10 minutes before the end of the cooking time and use the
residual heat to finish cooking.
%
O
15
Advertisement
Table of Contents
